1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 19 Code 128
Steve Davis
Phorum Expert
*****
Posts: 1,402
Threads: 70
Joined: Oct 2007
City: Linn Creek, MO
#3

12-31-2019, 06:54 PM
No need to worry about the outer winding, you will need to replace it any way. Unwind the outer winding and use your finger nail to scrape off the plastic. Then, as Terry said, use a heat gun and a rag to remove the wax. It would also be a good idea to bake the coil form at 200 degrees for about 30 minutes before rewinding.

Steve
M R Radios   C M Tubes
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 19 Code 128 - by Simon Wa3uay - 12-31-2019, 03:51 PM
RE: Philco 19 Code 128 - by Radioroslyn - 12-31-2019, 04:19 PM
RE: Philco 19 Code 128 - by Steve Davis - 12-31-2019, 06:54 PM
RE: Philco 19 Code 128 - by Forrest - 12-31-2019, 08:15 PM
RE: Philco 19 Code 128 - by Simon Wa3uay - 01-02-2020, 01:47 PM
RE: Philco 19 Code 128 - by Steve Davis - 01-02-2020, 02:31 PM
RE: Philco 19 Code 128 - by Simon Wa3uay - 01-21-2020, 01:27 PM
RE: Philco 19 Code 128 - by Forrest - 01-21-2020, 02:19 PM
RE: Philco 19 Code 128 - by Simon Wa3uay - 01-21-2020, 05:24 PM
RE: Philco 19 Code 128 - by Simon Wa3uay - 02-16-2020, 03:33 PM
RE: Philco 19 Code 128 - by Radioroslyn - 02-16-2020, 03:56 PM
RE: Philco 19 Code 128 - by Simon Wa3uay - 02-18-2020, 01:32 PM
RE: Philco 19 Code 128 - by Simon Wa3uay - 03-05-2020, 11:39 AM
RE: Philco 19 Code 128 - by Radioroslyn - 03-05-2020, 04:29 PM
RE: Philco 19 Code 128 - by Simon Wa3uay - 03-05-2020, 05:02 PM
RE: Philco 19 Code 128 - by Simon Wa3uay - 03-17-2020, 03:41 PM
RE: Philco 19 Code 128 - by Radioroslyn - 03-17-2020, 05:41 PM
RE: Philco 19 Code 128 - by Simon Wa3uay - 03-17-2020, 07:57 PM
RE: Philco 19 Code 128 - by Radioroslyn - 03-17-2020, 08:10 PM
RE: Philco 19 Code 128 - by Simon Wa3uay - 03-29-2020, 10:14 AM
RE: Philco 19 Code 128 - by Radioroslyn - 03-29-2020, 10:40 AM
RE: Philco 19 Code 128 - by Simon Wa3uay - 04-13-2020, 01:27 PM



Users browsing this thread: 16 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 6829 online users. [Complete List]
» 1 Member(s) | 6828 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration