BAKELITE BLOCK TYPE capacitors

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

BAKELITE BLOCK TYPE capacitors

Nathan Slingerland
Super Moderator

Posts: 1,874
Threads: 212
Joined: May 2015
City: Seattle State, Province, Country: WA

#10

01-02-2020, 12:06 PM

I have seen them sometimes be mica - sometimes not. To distinguish I check small value bakelite blocks with my capacitance meter. If it won't give a reading or it's off my more than say 10% I replace.

Find

« Next Oldest | Next Newest »

Messages In This Thread

BAKELITE BLOCK TYPE capacitors - by fenbach - 12-31-2019, 08:51 PM

RE: BAKELITE BLOCK TYPE capacitors - by Paul Philco322 - 12-31-2019, 09:07 PM

RE: BAKELITE BLOCK TYPE capacitors - by radiodale - 12-31-2019, 10:43 PM

RE: BAKELITE BLOCK TYPE capacitors - by Nathan Slingerland - 12-31-2019, 10:48 PM

RE: BAKELITE BLOCK TYPE capacitors - by Steve Davis - 12-31-2019, 10:55 PM

RE: BAKELITE BLOCK TYPE capacitors - by morzh - 01-01-2020, 02:27 PM

RE: BAKELITE BLOCK TYPE capacitors - by Radioroslyn - 01-01-2020, 06:39 PM

RE: BAKELITE BLOCK TYPE capacitors - by Kestas - 01-01-2020, 09:29 PM

RE: BAKELITE BLOCK TYPE capacitors - by morzh - 01-02-2020, 10:58 AM

RE: BAKELITE BLOCK TYPE capacitors - by Nathan Slingerland - 01-02-2020, 12:06 PM

RE: BAKELITE BLOCK TYPE capacitors - by fenbach - 01-04-2020, 02:11 PM

RE: BAKELITE BLOCK TYPE capacitors - by Jake Blake - 01-04-2020, 02:42 PM

RE: BAKELITE BLOCK TYPE capacitors - by Steve Davis - 01-04-2020, 08:45 PM

RE: BAKELITE BLOCK TYPE capacitors - by morzh - 01-04-2020, 08:59 PM

RE: BAKELITE BLOCK TYPE capacitors - by Stall-U-Rated - 01-04-2020, 09:20 PM

RE: BAKELITE BLOCK TYPE capacitors - by Steve Davis - 01-04-2020, 10:12 PM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone, As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

Who's Online

There are currently 4997 online users. [Complete List]
» 2 Member(s) | 4995 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me