1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
38-2 Audio Yes Signal No
radiodale
Member
***
Posts: 93
Threads: 20
Joined: Aug 2014
City: Greenville, TX
#2

01-07-2020, 10:22 PM
Check to see if the oscillator is working. Put a scope on the grid or put another radio close and listen for the tone at 470kHz above your tuned frequency.
Dale


http://www.dalesantiqueradio.com/
Website Find
« Next Oldest | Next Newest »


Messages In This Thread
38-2 Audio Yes Signal No - by dfields69 - 01-07-2020, 08:03 PM
RE: 38-2 Audio Yes Signal No - by radiodale - 01-07-2020, 10:22 PM
RE: 38-2 Audio Yes Signal No - by dfields69 - 01-08-2020, 12:32 AM
RE: 38-2 Audio Yes Signal No - by morzh - 01-08-2020, 09:48 AM
RE: 38-2 Audio Yes Signal No - by RodB - 01-08-2020, 08:53 PM
RE: 38-2 Audio Yes Signal No - by dfields69 - 01-08-2020, 10:46 PM
RE: 38-2 Audio Yes Signal No - by radiodale - 01-09-2020, 10:04 PM
RE: 38-2 Audio Yes Signal No - by dfields69 - 01-10-2020, 11:52 PM
RE: 38-2 Audio Yes Signal No - by radiodale - 01-11-2020, 12:18 AM
RE: 38-2 Audio Yes Signal No - by dfields69 - 01-11-2020, 02:05 PM
RE: 38-2 Audio Yes Signal No - by dfields69 - 01-14-2020, 08:37 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM

[-]
Who's Online
There are currently 3386 online users. [Complete List]
» 2 Member(s) | 3384 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration