1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Vibrator question
Arohn19
Member
***
Posts: 66
Threads: 7
Joined: Jun 2019
City: Austin State, Province, Country: Minnesota
#1

01-25-2020, 07:59 PM
Is there any other way to test a vibrator to see if it’s working without actually running it? I don’t have a battery big enough to test with. I did touch two pins and it does have continuity in two of the pins but not the other two. ( I’m assuming that’s a good sign since according to what I’ve heard and kinda picking it out on the schematic that only pins normally should draw continuity) One of the other two is ground and I don’t know the purpose of the other one.
Find
« Next Oldest | Next Newest »


Messages In This Thread
Vibrator question - by Arohn19 - 01-25-2020, 07:59 PM
RE: Vibrator question - by morzh - 01-25-2020, 11:19 PM
RE: Vibrator question - by Chas - 01-26-2020, 12:20 AM
RE: Vibrator question - by Arohn19 - 01-26-2020, 12:34 PM
RE: Vibrator question - by Phlogiston - 01-26-2020, 12:52 PM
RE: Vibrator question - by Arohn19 - 01-26-2020, 07:57 PM
RE: Vibrator question - by Chas - 01-26-2020, 09:03 PM
RE: Vibrator question - by fenbach - 01-27-2020, 12:40 AM
RE: Vibrator question - by Phlogiston - 01-27-2020, 11:35 AM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

[-]
Who's Online
There are currently 4140 online users. [Complete List]
» 1 Member(s) | 4139 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)