Vibrator question

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Vibrator question

Phlogiston
Radio-Fixer-Upper

Posts: 2,118
Threads: 112
Joined: Jun 2010
City: Medford OR (OR what?)

01-27-2020, 11:35 AM

Most of these vibrators were inside of a rubber cover - inside of the can. This was to dampen noise. Now the rubber is breaking down adding to the contamination on the contacts.

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/

Website Find

« Next Oldest | Next Newest »

Messages In This Thread

Vibrator question - by Arohn19 - 01-25-2020, 07:59 PM

RE: Vibrator question - by morzh - 01-25-2020, 11:19 PM

RE: Vibrator question - by Chas - 01-26-2020, 12:20 AM

RE: Vibrator question - by Arohn19 - 01-26-2020, 12:34 PM

RE: Vibrator question - by Phlogiston - 01-26-2020, 12:52 PM

RE: Vibrator question - by Arohn19 - 01-26-2020, 07:57 PM

RE: Vibrator question - by Chas - 01-26-2020, 09:03 PM

RE: Vibrator question - by fenbach - 01-27-2020, 12:40 AM

RE: Vibrator question - by Phlogiston - 01-27-2020, 11:35 AM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

Who's Online

There are currently 4941 online users. [Complete List]
» 1 Member(s) | 4940 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me