Refaux Pro

Thread Rating:

Refaux Pro

kedyer
Junior Member

Posts: 13
Threads: 3
Joined: Nov 2019
City: Morganton State, Province, Country: Georgia USA

02-09-2020, 11:34 PM

Thanks for the reply, information, and the welcome. Nice to meet you and take care.

Find

« Next Oldest | Next Newest »

Messages In This Thread

Refaux Pro - by kedyer - 02-09-2020, 09:35 PM

RE: Refaux Pro - by Radioroslyn - 02-09-2020, 11:02 PM

RE: Refaux Pro - by kedyer - 02-09-2020, 11:34 PM

RE: Refaux Pro - by John Bartley - 02-09-2020, 11:43 PM

RE: Refaux Pro - by kedyer - 02-09-2020, 11:50 PM

RE: Refaux Pro - by mikethedruid - 02-10-2020, 12:53 AM

RE: Refaux Pro - by Phlogiston - 02-10-2020, 12:13 PM

RE: Refaux Pro - by Paul Philco322 - 02-10-2020, 04:09 PM

RE: Refaux Pro - by klondike98 - 02-13-2020, 04:40 AM

RE: Refaux Pro - by kedyer - 02-13-2020, 11:01 AM

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM

Who's Online

There are currently 4956 online users. [Complete List]
» 2 Member(s) | 4954 Guest(s)