Philco 42-1008

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco 42-1008

Radioroslyn
Phorum Expert

Posts: 7,285
Threads: 268
Joined: Dec 2009
City: Roslyn Pa

02-24-2020, 10:26 PM

#26 provides the plate voltage for the osc so if it is open or disconnected the osc won't run. If you have been dittiling with the trimmers associated the the IF transformers you should use a signal generator and align them properly to the IF frequency. If not your asking for poor performance.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 42-1008 - by Burchjburch - 02-24-2020, 12:26 PM

RE: Philco 42-1008 - by klondike98 - 02-24-2020, 12:55 PM

RE: Philco 42-1008 - by Burchjburch - 02-24-2020, 01:25 PM

RE: Philco 42-1008 - by Radioroslyn - 02-24-2020, 02:22 PM

RE: Philco 42-1008 - by Burchjburch - 02-24-2020, 02:36 PM

RE: Philco 42-1008 - by Radioroslyn - 02-24-2020, 08:29 PM

RE: Philco 42-1008 - by Burchjburch - 02-24-2020, 09:32 PM

RE: Philco 42-1008 - by Radioroslyn - 02-24-2020, 10:26 PM

RE: Philco 42-1008 - by Burchjburch - 02-24-2020, 10:46 PM

RE: Philco 42-1008 - by Burchjburch - 05-14-2020, 11:45 AM

RE: Philco 42-1008 - by Radioroslyn - 05-14-2020, 01:12 PM

RE: Philco 42-1008 - by Burchjburch - 05-14-2020, 03:32 PM

RE: Philco 42-1008 - by Radioroslyn - 05-14-2020, 04:45 PM

RE: Philco 42-1008 - by Burchjburch - 05-14-2020, 04:56 PM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM
Philco 42-1008 conversion kit
I read about a kit to convert the variable speed changer in the Philco 42-1008 into a single speed unit. That would rem...alangard — 09:30 PM
HiFi (Chifi) tube amp build - but my own design.
Tim Well...a chassis is metal. Magnetic or not, it does not matter. A transformer has some hum to it. It is natural. Th...morzh — 08:40 PM
Hickok AC51 tube tester
I thought the 83 tube was bad because it looked white but it tests strong. Blue gassy though. I checked the fuse, it was...martinj — 08:37 PM

Who's Online

There are currently 5235 online users. [Complete List]
» 1 Member(s) | 5234 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me