Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Westinghouse tuning issue
#8

Quote:Another question - do you know of any source for the clear plastic tuning dial cover?

Dialcover.com makes one for the WR-217:

https://dialcover.com/

Don, a lot of the Zeniths I've been working on lately are ~ 1000 ohm field coils.

I picked up the Ferret box about 3 years ago.  Prior to that I used one that has most of the tolex covering peeling off.... looks horrible but it still works fine.

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"


Messages In This Thread
Westinghouse tuning issue - by 45philcodon - 03-15-2020, 04:39 PM
RE: Westinghouse tuning issue - by Radioroslyn - 03-15-2020, 05:36 PM
RE: Westinghouse tuning issue - by 45philcodon - 03-15-2020, 07:01 PM
RE: Westinghouse tuning issue - by Radioroslyn - 03-15-2020, 09:21 PM
RE: Westinghouse tuning issue - by Eliot Ness - 03-16-2020, 12:16 PM
RE: Westinghouse tuning issue - by 45philcodon - 03-16-2020, 04:24 PM
RE: Westinghouse tuning issue - by 45philcodon - 03-16-2020, 04:28 PM
RE: Westinghouse tuning issue - by Eliot Ness - 03-16-2020, 04:55 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently no members online.

>