1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Next Project - 37-116
462ron
Phorum Expert
*****
Posts: 813
Threads: 49
Joined: Feb 2013
City: Shenandoah, State, Province, Country: Pennsylvania
#5

04-03-2020, 07:40 AM
Terrific job on those cabinets indeed. Do you have spray equipment or use rattle cans? I have a 37-116 that someone kept a house plant on the top. There is water damage, but I doubt I would ever find a perfect match for the toner so I’m looking at refinishing the whole cabinet instead of just the top. I don’t relish doing that with rattle cans on such a big cabinet! 

Ron
Bendix 0626.      RCA 8BX5.   RCA T64
Philco 41-250.    Philco49-500
GE 201.             Philco 39-25
Motorola 61X13. Philco 46-42        Crosley 52TQ
Philco 37-116.    Philco 70
AK 35                Philco 46-350
Philco 620B.       Zenith Transoceanic B-600
Philco 60B.         Majestic 50
Philco 52-944.    AK 84
Find
« Next Oldest | Next Newest »


Messages In This Thread
Next Project - 37-116 - by rfeenstra - 04-02-2020, 12:57 PM
RE: Next Project - 37-116 - by KCMike - 04-02-2020, 01:15 PM
RE: Next Project - 37-116 - by Eliot Ness - 04-02-2020, 01:41 PM
RE: Next Project - 37-116 - by rfeenstra - 04-03-2020, 01:13 AM
RE: Next Project - 37-116 - by 462ron - 04-03-2020, 07:40 AM
RE: Next Project - 37-116 - by Jake Blake - 04-03-2020, 08:08 AM
RE: Next Project - 37-116 - by Bill Bacco - 04-03-2020, 08:09 AM
RE: Next Project - 37-116 - by rfeenstra - 04-03-2020, 11:28 AM
RE: Next Project - 37-116 - by morzh - 04-03-2020, 03:36 PM
RE: Next Project - 37-116 - by rfeenstra - 04-03-2020, 07:17 PM
RE: Next Project - 37-116 - by rfeenstra - 04-03-2020, 11:18 PM
RE: Next Project - 37-116 - by RodB - 04-04-2020, 08:47 AM
RE: Next Project - 37-116 - by rfeenstra - 04-04-2020, 01:40 PM
RE: Next Project - 37-116 - by 462ron - 04-04-2020, 01:45 PM
RE: Next Project - 37-116 - by rfeenstra - 04-04-2020, 03:27 PM
RE: Next Project - 37-116 - by rfeenstra - 04-05-2020, 03:22 PM
RE: Next Project - 37-116 - by rfeenstra - 04-06-2020, 12:24 PM
RE: Next Project - 37-116 - by Jake Blake - 04-06-2020, 02:01 PM
RE: Next Project - 37-116 - by rfeenstra - 04-07-2020, 09:02 PM
RE: Next Project - 37-116 - by rfeenstra - 04-08-2020, 11:31 PM
RE: Next Project - 37-116 - by rfeenstra - 04-09-2020, 10:42 PM
RE: Next Project - 37-116 - by 462ron - 04-10-2020, 07:35 AM
RE: Next Project - 37-116 - by rfeenstra - 04-10-2020, 03:55 PM
RE: Next Project - 37-116 - by KCMike - 04-10-2020, 04:40 PM
RE: Next Project - 37-116 - by PhilcoJohn - 04-11-2020, 07:23 PM
RE: Next Project - 37-116 - by rfeenstra - 04-13-2020, 09:51 PM
RE: Next Project - 37-116 - by madsowry - 04-13-2020, 11:52 PM
RE: Next Project - 37-116 - by Steve D - 04-14-2020, 08:40 AM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 3048 online users. [Complete List]
» 1 Member(s) | 3047 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration