40-180 phono plug

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

40-180 phono plug

radiodale
Member

Posts: 93
Threads: 20
Joined: Aug 2014
City: Greenville, TX

#12

04-08-2020, 04:02 PM

There are three terminals on the 1/8 in. jack. One is for left and one for right. Put one resistor on each and connect the two loose ends together, then attach capacitor. Third terminal is ground. It is less complicated than Ron's schematic shows.

Dale

http://www.dalesantiqueradio.com/

Website Find

« Next Oldest | Next Newest »

Messages In This Thread

40-180 phono plug - by Patrick - 04-07-2020, 09:27 PM

RE: 40-180 phono plug - by radiodale - 04-07-2020, 10:01 PM

RE: 40-180 phono plug - by Ron Ramirez - 04-07-2020, 10:02 PM

RE: 40-180 phono plug - by Patrick - 04-08-2020, 06:33 AM

RE: 40-180 phono plug - by Patrick - 04-08-2020, 06:46 AM

RE: 40-180 phono plug - by Ron Ramirez - 04-08-2020, 07:56 AM

RE: 40-180 phono plug - by Patrick - 04-08-2020, 09:20 AM

RE: 40-180 phono plug - by radiodale - 04-08-2020, 09:28 AM

RE: 40-180 phono plug - by Patrick - 04-08-2020, 12:46 PM

RE: 40-180 phono plug - by radiodale - 04-08-2020, 03:41 PM

RE: 40-180 phono plug - by Patrick - 04-08-2020, 03:56 PM

RE: 40-180 phono plug - by radiodale - 04-08-2020, 04:02 PM

RE: 40-180 phono plug - by Patrick - 04-08-2020, 04:06 PM

RE: 40-180 phono plug - by Steve Davis - 04-08-2020, 04:58 PM

RE: 40-180 phono plug - by Ron Ramirez - 04-08-2020, 05:18 PM

RE: 40-180 phono plug - by Patrick - 04-08-2020, 05:23 PM

RE: 40-180 phono plug - by Ron Ramirez - 04-08-2020, 05:46 PM

RE: 40-180 phono plug - by Patrick - 04-08-2020, 05:54 PM

RE: 40-180 phono plug - by Ron Ramirez - 04-08-2020, 05:55 PM

View a Printable Version

Users browsing this thread: 4 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me