40-180 phono plug

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

40-180 phono plug

Patrick
Senior Member

Posts: 365
Threads: 76
Joined: Oct 2014
City: Winter Haven, FL

#18

04-08-2020, 05:54 PM

Thanks Ron. I kinda figured that was the purpose of the cap, but I wasn't sure. I just started recapping the radio, so it will be a few days until I'm ready to install the jack and see if it works. I'll post the results. Thanks again.

Find

« Next Oldest | Next Newest »

Messages In This Thread

40-180 phono plug - by Patrick - 04-07-2020, 09:27 PM

RE: 40-180 phono plug - by radiodale - 04-07-2020, 10:01 PM

RE: 40-180 phono plug - by Ron Ramirez - 04-07-2020, 10:02 PM

RE: 40-180 phono plug - by Patrick - 04-08-2020, 06:33 AM

RE: 40-180 phono plug - by Patrick - 04-08-2020, 06:46 AM

RE: 40-180 phono plug - by Ron Ramirez - 04-08-2020, 07:56 AM

RE: 40-180 phono plug - by Patrick - 04-08-2020, 09:20 AM

RE: 40-180 phono plug - by radiodale - 04-08-2020, 09:28 AM

RE: 40-180 phono plug - by Patrick - 04-08-2020, 12:46 PM

RE: 40-180 phono plug - by radiodale - 04-08-2020, 03:41 PM

RE: 40-180 phono plug - by Patrick - 04-08-2020, 03:56 PM

RE: 40-180 phono plug - by radiodale - 04-08-2020, 04:02 PM

RE: 40-180 phono plug - by Patrick - 04-08-2020, 04:06 PM

RE: 40-180 phono plug - by Steve Davis - 04-08-2020, 04:58 PM

RE: 40-180 phono plug - by Ron Ramirez - 04-08-2020, 05:18 PM

RE: 40-180 phono plug - by Patrick - 04-08-2020, 05:23 PM

RE: 40-180 phono plug - by Ron Ramirez - 04-08-2020, 05:46 PM

RE: 40-180 phono plug - by Patrick - 04-08-2020, 05:54 PM

RE: 40-180 phono plug - by Ron Ramirez - 04-08-2020, 05:55 PM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

Who's Online

There are currently 3547 online users. [Complete List]
» 1 Member(s) | 3546 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me