Q1791WA - first project!

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Q1791WA - first project!

Radioroslyn
Phorum Expert

Posts: 7,285
Threads: 268
Joined: Dec 2009
City: Roslyn Pa

#14

04-20-2020, 09:24 PM

Would that cap be connected between two of the speakers?? Is the hum present when you select the radio or tape position?

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry

Find

« Next Oldest | Next Newest »

Messages In This Thread

Q1791WA - first project! - by Qbinalex - 08-13-2019, 12:14 AM

RE: Q1791WA - first project! - by morzh - 08-13-2019, 08:37 AM

RE: Q1791WA - first project! - by Qbinalex - 08-13-2019, 09:49 AM

RE: Q1791WA - first project! - by Scott D - 08-18-2019, 10:35 PM

RE: Q1791WA - first project! - by Stall-U-Rated - 08-19-2019, 12:30 AM

RE: Q1791WA - first project! - by Arohn19 - 08-19-2019, 08:39 PM

RE: Q1791WA - first project! - by Arohn19 - 08-19-2019, 08:46 PM

RE: Q1791WA - first project! - by Qbinalex - 08-19-2019, 10:56 PM

RE: Q1791WA - first project! - by mikethedruid - 08-19-2019, 11:08 PM

RE: Q1791WA - first project! - by Jake Blake - 08-20-2019, 07:41 AM

RE: Q1791WA - first project! - by Ron Ramirez - 08-20-2019, 02:05 PM

RE: Q1791WA - first project! - by Qbinalex - 08-20-2019, 03:45 PM

RE: Q1791WA - first project! - by Qbinalex - 04-20-2020, 08:43 PM

RE: Q1791WA - first project! - by Radioroslyn - 04-20-2020, 09:24 PM

RE: Q1791WA - first project! - by Qbinalex - 04-20-2020, 09:44 PM

RE: Q1791WA - first project! - by Radioroslyn - 04-20-2020, 10:15 PM

RE: Q1791WA - first project! - by Qbinalex - 04-20-2020, 10:28 PM

RE: Q1791WA - first project! - by Qbinalex - 05-08-2020, 09:48 PM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone, Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

Who's Online

There are currently 5800 online users. [Complete List]
» 1 Member(s) | 5799 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me