Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

High-Efficiency Aerial Question
#8

I know the feeling I really do not want to spend high dollars on something sealed just to open it and use it. I will wait for one opened or missing minor replaceable parts at a reasonable price. If that is possible. I'm really getting burned out on E-Bays bidders over pricing. My house was built in 1940 and has an antenna and ground built in. The antenna runs the length of the attic and the ground hooks under the house. Both connecting to a plate on the wall. All my radios work good off this except for my 77, but that's another story. So when you get your house just run the antenna in the attic that way nothing will be visible from outside.

Richard


Messages In This Thread
[No subject] - by Chuck Schwark - 03-07-2006, 10:16 AM
[No subject] - by Robbie Roberts - 03-07-2006, 04:19 PM
[No subject] - by Chuck Schwark - 03-07-2006, 05:36 PM
[No subject] - by Robbie Roberts - 03-07-2006, 06:01 PM
[No subject] - by rjm - 03-07-2006, 06:33 PM
[No subject] - by Robbie Roberts - 03-07-2006, 06:40 PM
[No subject] - by rjm - 03-07-2006, 08:20 PM
[No subject] - by Robbie Roberts - 03-07-2006, 08:32 PM
[No subject] - by rjm - 03-07-2006, 08:52 PM
[No subject] - by Robbie Roberts - 03-07-2006, 09:13 PM
[No subject] - by rjm - 03-07-2006, 09:24 PM
[No subject] - by Robbie Roberts - 03-07-2006, 11:14 PM
[No subject] - by rjm - 03-07-2006, 11:35 PM
[No subject] - by Robbie Roberts - 03-08-2006, 02:44 AM
Antenna - by Doug Houston - 03-12-2006, 12:44 AM
[No subject] - by BDM - 07-13-2008, 02:08 AM
[No subject] - by exray - 07-13-2008, 03:21 AM
[No subject] - by BDM - 07-13-2008, 03:32 AM
[No subject] - by exray - 07-13-2008, 03:37 AM
[No subject] - by BDM - 07-13-2008, 03:41 AM
[No subject] - by etech - 07-13-2008, 11:14 AM
[No subject] - by BDM - 07-31-2008, 11:52 AM
Re: High-Efficiency Aerial Question - by BDM - 09-11-2008, 06:19 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM

[-]
Who's Online
There are currently 5158 online users. [Complete List]
» 3 Member(s) | 5155 Guest(s)
AvatarAvatarAvatar

>