1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 18
andyjon100
Junior Member
**
Posts: 10
Threads: 2
Joined: Jan 2011
#3

02-06-2011, 07:13 PM
No... it's like the ones on the 1935 (fall 1934) page... They use the same photo for the 18x, 49x, 118x, and 144x. but like the 1933 model you showed me, it has the lyres atop each fluted side trim. The inside label tags it as a Model 18... not 18x... The place I got this one also has another pretty rough Philco R/P Console with a missing label.... It has almost the same face as my 41-250, but the dial scale has more printing on it, and it has the more rectangular push buttons. It has a low speaker, and mid pull out phonograph. On either side of the phonograph, there are large rectangular openings that look like record storage pockets missing the doors.. It was very crowded in, and I couldn't get a very good look at it. I could snap it up real cheap... but I don't know what I would do with it. I don't really want any more basket cases....
Andy
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 18 - by andyjon100 - 02-05-2011, 10:34 PM
Re: Philco 18 - by Ron Ramirez - 02-05-2011, 10:43 PM
Re: Philco 18 - by andyjon100 - 02-06-2011, 07:13 PM
Re: Philco 18 - by Ron Ramirez - 02-06-2011, 09:08 PM
Re: Philco 18 - by andyjon100 - 02-07-2011, 02:00 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM

[-]
Who's Online
There are currently 4586 online users. [Complete List]
» 1 Member(s) | 4585 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios