High voltage readings

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

High voltage readings

Radioroslyn
Phorum Expert

Posts: 7,285
Threads: 268
Joined: Dec 2009
City: Roslyn Pa

05-08-2020, 08:44 PM

You might want to have a look at your cathode resistors, it could be that you have a tube that isn't drawing it's fair share of current.
GL

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry

Find

« Next Oldest | Next Newest »

Messages In This Thread

High voltage readings - by Tom45acp - 05-08-2020, 05:37 PM

RE: High voltage readings - by gregb - 05-08-2020, 05:50 PM

RE: High voltage readings - by Tom45acp - 05-08-2020, 07:17 PM

RE: High voltage readings - by Radioroslyn - 05-08-2020, 08:44 PM

RE: High voltage readings - by Tom45acp - 05-09-2020, 04:00 PM

RE: High voltage readings - by Steve Davis - 05-09-2020, 05:57 PM

RE: High voltage readings - by morzh - 05-09-2020, 06:31 PM

RE: High voltage readings - by Tom45acp - 05-10-2020, 08:29 PM

RE: High voltage readings - by morzh - 05-10-2020, 09:01 PM

RE: High voltage readings - by Tom45acp - 05-11-2020, 08:59 AM

RE: High voltage readings - by morzh - 05-11-2020, 10:42 AM

RE: High voltage readings - by Tom45acp - 05-11-2020, 06:44 PM

RE: High voltage readings - by morzh - 05-11-2020, 08:45 PM

RE: High voltage readings - by Tom45acp - 05-12-2020, 08:44 AM

RE: High voltage readings - by RodB - 05-12-2020, 09:19 AM

RE: High voltage readings - by morzh - 05-12-2020, 10:18 AM

RE: High voltage readings - by Tom45acp - 05-12-2020, 12:12 PM

View a Printable Version

Users browsing this thread: 7 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

Who's Online

There are currently 6832 online users. [Complete List]
» 2 Member(s) | 6830 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me