RCA 66X2 SMD

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

RCA 66X2 SMD

Eric Adams
Phorum Expert

Posts: 825
Threads: 113
Joined: Aug 2012
City: The Villages State, Province, Country: Florida

05-13-2020, 09:44 AM

Found it! Thanks, Ed. I was able to find the problem. There was a small 330mmf mica cap connected at the 12SQ7. The problem in locating it was that it was stuck next to the chassis and was covered by the 2 electrolytics that I installed. Replaced it and all is fine now! THANKS!

Eric
The Villages, FL
Member: Philco Phorum, ARF, ARCI & Radiomuseum.org

(This post was last modified: 05-13-2020, 09:45 AM by Eric Adams.)

Website Find

« Next Oldest | Next Newest »

Messages In This Thread

RCA 66X2 SMD - by Eric Adams - 05-12-2020, 10:28 AM

RE: RCA 66X2 SMD - by EdHolland - 05-12-2020, 01:17 PM

RE: RCA 66X2 SMD - by Eric Adams - 05-13-2020, 09:44 AM

RE: RCA 66X2 SMD - by EdHolland - 05-13-2020, 11:42 AM

RE: RCA 66X2 SMD - by Eric Adams - 05-13-2020, 11:45 AM

RE: RCA 66X2 SMD - by EdHolland - 05-14-2020, 12:46 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone, Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

Who's Online

There are currently 6262 online users. [Complete List]
» 1 Member(s) | 6261 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me