Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

GE radio I am glad I didn't sell.
#5

That is a very nice little radio-phono indeed! Like I said, I think my chassis came from one for some odd reason. Perhaps the chassis was badly damaged in the table radio and they had the chassis from a damaged radio-phono version? It's a straight HJ-624 now and these seem to be good little radios with a true six tubes along with the Ballast. I have seen some radio-phono units for sale this past year, but usually hours away from me. Even though the mention of one gets the evil eye from certain family members, I wouldn't pass up a nice example.

No matter where you go, there you are.


Messages In This Thread
GE radio I am glad I didn't sell. - by Jayce - 08-13-2020, 06:55 PM
RE: GE radio I am glad I didn't sell. - by Jayce - 08-14-2020, 03:30 PM
RE: GE radio I am glad I didn't sell. - by Jayce - 08-14-2020, 07:12 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
PT-6 antenna connections
Hi Bridcarl +1 on the others.  Pin 6 of the 7C6 is the AVC Diode so it is appropriate that that pin 4 of the coil con...MrFixr55 — 07:30 AM
462ron
Joseph, this is beyond awesome. A lot of thought and engineering went into this and you hit a home run! Now I must save ...462ron — 07:27 AM
Cannot Adjust an IF Transformer’s cores
Outstanding work indeed. I wish I could come up with solutions like this.slford310 — 11:16 PM
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM

[-]
Who's Online
There are currently 4605 online users. [Complete List]
» 1 Member(s) | 4604 Guest(s)
Avatar

>