40-180 Re-Cap questions

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Guest
Unregistered

03-14-2006, 11:31 AM

Thanks, that's exactly what I was looking for.

Do you think it's ok to replace the 1250pf and 5300pf mica's with high voltage (1K) ceramic disks? I found those in values much closer, 1200pf and 5600pf respectively. The only difference I can see is in the tolerance. The mica's are about 5% and the ceramics are 10%. I can't think of a reason why not.

Gary: I grew up in EG. I was a member of the EGARC for a *long* time back in the 70's and 80's.

Chuck - WB9RPL

« Next Oldest | Next Newest »

Messages In This Thread

40-180 Re-Cap questions - by Guest - 03-13-2006, 11:20 AM

[No subject] - by 49Stude63 - 03-13-2006, 08:01 PM

Re: 40-180 Re-Cap questions - by n9vu - 03-13-2006, 08:45 PM

[No subject] - by Guest - 03-14-2006, 11:31 AM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM

Who's Online

There are currently 6187 online users. [Complete List]
» 1 Member(s) | 6186 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me