Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Scott items
#16
Wink 

Very nice items guys! Yes Mike,  I'm a bit slow to respond as I'm not often on this forum  Icon_smile

I'm mostly into McIntosh, Marantz and Fisher stereo items and I love vintage turntables. I have several McIntosh preamps including two C22's and a MX110. 

Here's a few of my many McIntosh amplifiers. I restored the ones in this photo. As well as the electronics I chromed the chassis and sent them out for silkscreening. I'll show some Marantz items as soon as I get photos.....


Attached Files Image(s)
   


Messages In This Thread
Scott items - by thirtiesradio - 08-26-2018, 09:10 PM
RE: Scott items - by Arran - 08-27-2018, 05:11 AM
RE: Scott items - by Ron Ramirez - 08-27-2018, 06:15 AM
RE: Scott items - by thirtiesradio - 08-27-2018, 03:58 PM
RE: Scott items - by thirtiesradio - 08-28-2018, 12:40 AM
RE: Scott items - by thirtiesradio - 08-28-2018, 12:53 AM
RE: Scott items - by Cliff Byers - 07-20-2019, 10:22 AM
RE: Scott items - by thirtiesradio - 09-01-2020, 01:58 PM
RE: Scott items - by morzh - 09-01-2020, 03:21 PM
RE: Scott items - by Cliff Byers - 09-01-2020, 05:00 PM
RE: Scott items - by rfeenstra - 09-01-2020, 07:39 PM
RE: Scott items - by Cliff Byers - 09-01-2020, 08:00 PM
RE: Scott items - by rfeenstra - 09-01-2020, 11:21 PM
RE: Scott items - by Cliff Byers - 09-02-2020, 01:32 PM
RE: Scott items - by rfeenstra - 09-02-2020, 05:29 PM
RE: Scott items - by thirtiesradio - 09-23-2020, 07:43 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM
Looking for verification of correct schematic.
Klondike98, Thank you. I'll double check that SN and get back to you. GarySP, Thank you for the schematic.RossH — 12:13 AM
Looking for verification of correct schematic.
I think you have the correct take on your set. Ron's annotated early schematics that note the below B22000 serial numbe...klondike98 — 12:04 AM
Looking for verification of correct schematic.
Hello Ross. The Philco Radio Library located at the bottom of the page has the schematic with the tube count you have. ...GarySP — 10:48 PM
HiFi (Chifi) tube amp build - but my own design.
Tim It's be interesting if you put your schematic here. Who knows, you could get some advice from a few folks here. ...morzh — 10:01 PM
Philco 42-390, code 121 speaker
Thanks for that information. It would appear from the output transformer parts list that the transformer that was origi...Stevelog — 07:21 PM

[-]
Who's Online
There are currently 1243 online users. [Complete List]
» 1 Member(s) | 1242 Guest(s)
Avatar

>