Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Atwater Kent 708
#4

In spite of the tubes being very weak, The radio performs quite well. There is a dearth of adjustments for the 4 frequency bands, so only the BC band is close in dial tracking. I'll do more investigation to see if it is possible to get the other bands closer on the dial. This radio uses an IF of 472.5 khz. The "sealed" AK adjustments were very close. I'd much rather deal with the caps in a Philco than the caps in this radio. There are other areas, such as the power transformer, that are much easier to deal with on the AK. Nice looking radio. I hope I can do the refinish justice.


Messages In This Thread
Atwater Kent 708 - by rfeenstra - 10-05-2020, 12:51 AM
RE: Atwater Kent 708 - by rfeenstra - 10-05-2020, 12:53 AM
RE: Atwater Kent 708 - by rfeenstra - 10-05-2020, 12:54 AM
RE: Atwater Kent 708 - by rfeenstra - 10-05-2020, 01:05 AM
RE: Atwater Kent 708 - by morzh - 10-05-2020, 09:25 AM
RE: Atwater Kent 708 - by Phlogiston - 10-05-2020, 10:51 AM
RE: Atwater Kent 708 - by rfeenstra - 10-05-2020, 12:00 PM
RE: Atwater Kent 708 - by rfeenstra - 10-05-2020, 08:57 PM
RE: Atwater Kent 708 - by Eliot Ness - 10-06-2020, 08:15 AM
RE: Atwater Kent 708 - by morzh - 10-06-2020, 10:31 AM
RE: Atwater Kent 708 - by Phlogiston - 10-06-2020, 10:50 AM
RE: Atwater Kent 708 - by morzh - 10-06-2020, 03:21 PM
RE: Atwater Kent 708 - by rfeenstra - 10-06-2020, 09:09 PM
RE: Atwater Kent 708 - by Eliot Ness - 10-07-2020, 01:57 PM
RE: Atwater Kent 708 - by rfeenstra - 10-17-2020, 11:11 PM
RE: Atwater Kent 708 - by Phlogiston - 10-18-2020, 10:07 AM
RE: Atwater Kent 708 - by rfeenstra - 10-18-2020, 12:32 PM
RE: Atwater Kent 708 - by rfeenstra - 10-25-2020, 03:43 PM
RE: Atwater Kent 708 - by Paul Philco322 - 10-25-2020, 05:58 PM
RE: Atwater Kent 708 - by Eliot Ness - 10-26-2020, 01:34 PM
RE: Atwater Kent 708 - by Paul Philco322 - 10-26-2020, 08:57 PM
RE: Atwater Kent 708 - by rfeenstra - 11-04-2020, 01:20 PM
RE: Atwater Kent 708 - by NostalgiaRadioTime - 11-05-2020, 01:38 AM
RE: Atwater Kent 708 - by Eliot Ness - 11-05-2020, 08:47 AM
RE: Atwater Kent 708 - by rfeenstra - 11-05-2020, 10:32 PM
RE: Atwater Kent 708 - by tbone - 11-06-2020, 07:50 AM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM

[-]
Who's Online
There are currently no members online.

>