Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Admiral 6T01
#1

https://www.flickr.com/photos/92577012@N...9619080218

So I have this radio, I like the case, 6 tubes plays pretty good. Somebody replaced the original speaker with a Jensen, looks a bit messy but it plays good. Maybe better than the original speaker. It had a replacement electrolytic, but is was an oldie, replaced. Other caps changed out.

Only thing is that when you turn on you may think it is dead if it were not for pilot light. You need to turn volume knob up quite a bit to get sound. It plays at a decent volume but you need to turn vol control up more than most sets. Should I care? Is it speaker swap? Maybe vol. control had been replaced as well and not a good fit? What would make a set do this? 

The schematic on nostalgia air show this as a 5 tube, mine has 6?

It has puzzled me but it is not a rare valuable set but I wonder. I like it so it matters Icon_lol Icon_lol Icon_lol.

Paul

Tubetalk1


Messages In This Thread
Admiral 6T01 - by Paul Philco322 - 10-11-2020, 08:18 PM
RE: Admiral 6T01 - by Paul Philco322 - 10-18-2020, 12:05 PM
RE: Admiral 6T01 - by rfeenstra - 10-18-2020, 12:18 PM
RE: Admiral 6T01 - by Paul Philco322 - 10-18-2020, 12:50 PM
RE: Admiral 6T01 - by morzh - 10-18-2020, 01:45 PM
RE: Admiral 6T01 - by rfeenstra - 10-18-2020, 02:24 PM
RE: Admiral 6T01 - by Paul Philco322 - 10-18-2020, 05:20 PM
RE: Admiral 6T01 - by Paul Philco322 - 07-23-2022, 11:26 AM
RE: Admiral 6T01 - by MrFixr55 - 08-22-2022, 08:05 AM
RE: Admiral 6T01 - by Paul Philco322 - 08-22-2022, 08:34 AM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Gilfillan Brothers Car Radio?
There is a Mission Bell model 19/19A that could be what you’re looking for, Riders vol 4. It has the tube line-up of: 0Z...Joe Rossi — 05:01 PM
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
Hickok AC51 tube tester
How does the  5W4 and 83 tube filaments get fed?martinj — 12:25 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM

[-]
Who's Online
There are currently 2645 online users. [Complete List]
» 2 Member(s) | 2643 Guest(s)
AvatarAvatar

>