[ascion90]

Hi Terry,

thank you so much. They are ok I verified them with the meter. The Pin 6 of 6K6Gt is used to connect together the red wire of the IF Z302 with one leg of the C322 and one leg of the R314. I checked the voltage on this point and there is not Voltage at all. The second leg of the C322 goes to the ground and the second leg of the R314. goes to pin 4 of 6K6GT.

This is the reason I checked with the ohms between the red wire and the blue wire of the IF 302 and it was open. I supposed there was an open coil and opened the IF.

You can see the other parts of the post where I described what I did. I tried to find the open coil inside the IF Z302 between the blue wire and the red wire and discovered that the first section from the blue wire and the end of the 13 ohm coil was 3 ohms instead of 13, but the section of the second 10 ohms coil and the red wire was open.
This is the reason why I tried to find the open wire and now I have to rebuild it

Thanks for any suggestion


Camillo