Inside of a Philco 620 Cabinet

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Inside of a Philco 620 Cabinet

Ken G
Junior Member

Posts: 12
Threads: 1
Joined: Dec 2005

03-21-2006, 11:37 PM

I think the inside of cabinets were sprayed with stain . Minwax makes spray stains that i find work real well to refresh the look of cabinet insides .

Find

« Next Oldest | Next Newest »

Messages In This Thread

Inside of a Philco 620 Cabinet - by Derek D - 01-04-2006, 11:29 AM

[No subject] - by Bill Hutchinson - 01-04-2006, 05:54 PM

[No subject] - by Derek D - 01-05-2006, 11:52 AM

[No subject] - by Ron Ramirez - 01-05-2006, 12:23 PM

[No subject] - by Ron Ramirez - 01-05-2006, 12:35 PM

[No subject] - by Derek D - 01-05-2006, 12:42 PM

[No subject] - by 49Stude63 - 01-05-2006, 01:59 PM

[No subject] - by Doug Houston - 01-24-2006, 07:57 PM

[No subject] - by Ken G - 03-21-2006, 11:37 PM

View a Printable Version

Users browsing this thread: 3 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online

There are currently 6844 online users. [Complete List]
» 2 Member(s) | 6842 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me