Candohm Resister Help

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Candohm Resister Help

radio1
Member

Posts: 102
Threads: 13
Joined: May 2020
City: Clemmons State, Province, Country: NC

11-23-2020, 08:11 PM

Measure the ohms from the base of where that gray resistor (that someone added) attaches and to the candohm post that goes to ground - scrape deep into the metal at that post and also the base where the gray resistor attaches. What does it say?

Find

« Next Oldest | Next Newest »

Messages In This Thread

Candohm Resister Help - by Fredmann99 - 11-23-2020, 03:03 PM

RE: Candohm Resister Help - by morzh - 11-23-2020, 07:01 PM

RE: Candohm Resister Help - by radio1 - 11-23-2020, 08:11 PM

RE: Candohm Resister Help - by morzh - 11-23-2020, 08:41 PM

RE: Candohm Resister Help - by Fredmann99 - 11-23-2020, 10:15 PM

RE: Candohm Resister Help - by morzh - 11-23-2020, 10:53 PM

RE: Candohm Resister Help - by Fredmann99 - 12-01-2020, 10:05 AM

RE: Candohm Resister Help - by morzh - 12-01-2020, 02:41 PM

RE: Candohm Resister Help - by Fredmann99 - 12-01-2020, 08:18 PM

RE: Candohm Resister Help - by Arran - 12-03-2020, 11:13 PM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM

Who's Online

There are currently 6305 online users. [Complete List]
» 1 Member(s) | 6304 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me