11-26-2020, 11:56 PM
Kirk tried to mold them but didn't get a satisfactory result. The up shot of the whole process was that he ended up having them printed with a 3D printer but the cost was excessive abt $60 ea. That's why they are no longer produce. The 3D printed ones had there issues too. Monochromatic and lots of very fine scratches. If your not in a hurry you can find a parts set with a good escutcheon.
GL
GL
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got it!
Terry
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
