48-230 Antenna Loop

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

48-230 Antenna Loop

Daniel Bingamon
Member

Posts: 53
Threads: 7
Joined: Nov 2020
City: KINGS MILLS State, Province, Country: OH

#29

12-04-2020, 08:18 PM

Finally, I borrowed a signal generator from work and a frequency counter and was able to tease the IF a bit better. It finally received a station other than WLW.

However, I think the volume control is on it's way out. I haven't tried to take it apart yet.

Find

« Next Oldest | Next Newest »

Messages In This Thread

48-230 Antenna Loop - by Daniel Bingamon - 11-13-2020, 09:24 PM

RE: 48-230 Antenna Loop - by Radioroslyn - 11-14-2020, 01:34 PM

RE: 48-230 Antenna Loop - by Daniel Bingamon - 11-14-2020, 07:11 PM

RE: 48-230 Antenna Loop - by Daniel Bingamon - 11-14-2020, 07:50 PM

RE: 48-230 Antenna Loop - by Radioroslyn - 11-15-2020, 12:27 AM

RE: 48-230 Antenna Loop - by Daniel Bingamon - 11-15-2020, 09:38 AM

RE: 48-230 Antenna Loop - by Daniel Bingamon - 11-15-2020, 10:06 AM

RE: 48-230 Antenna Loop - by RodB - 11-15-2020, 12:09 PM

RE: 48-230 Antenna Loop - by morzh - 11-15-2020, 12:30 PM

RE: 48-230 Antenna Loop - by Radioroslyn - 11-15-2020, 01:18 PM

RE: 48-230 Antenna Loop - by Daniel Bingamon - 11-15-2020, 02:25 PM

RE: 48-230 Antenna Loop - by RodB - 11-15-2020, 02:44 PM

RE: 48-230 Antenna Loop - by Daniel Bingamon - 11-24-2020, 09:54 PM

RE: 48-230 Antenna Loop - by Daniel Bingamon - 11-25-2020, 12:19 AM

RE: 48-230 Antenna Loop - by Daniel Bingamon - 11-27-2020, 08:04 PM

RE: 48-230 Antenna Loop - by klondike98 - 11-29-2020, 09:40 PM

RE: 48-230 Antenna Loop - by Daniel Bingamon - 11-29-2020, 10:30 PM

RE: 48-230 Antenna Loop - by Radioroslyn - 11-30-2020, 11:34 AM

RE: 48-230 Antenna Loop - by Daniel Bingamon - 11-30-2020, 09:08 PM

RE: 48-230 Antenna Loop - by Radioroslyn - 12-01-2020, 12:32 AM

RE: 48-230 Antenna Loop - by Daniel Bingamon - 12-02-2020, 09:34 PM

RE: 48-230 Antenna Loop - by Daniel Bingamon - 12-02-2020, 11:42 PM

RE: 48-230 Antenna Loop - by Radioroslyn - 12-02-2020, 11:50 PM

RE: 48-230 Antenna Loop - by Daniel Bingamon - 12-03-2020, 08:14 AM

RE: 48-230 Antenna Loop - by Daniel Bingamon - 12-03-2020, 08:31 PM

RE: 48-230 Antenna Loop - by Radioroslyn - 12-03-2020, 11:53 PM

RE: 48-230 Antenna Loop - by Daniel Bingamon - 12-04-2020, 08:03 AM

RE: 48-230 Antenna Loop - by Daniel Bingamon - 12-04-2020, 08:18 PM

RE: 48-230 Antenna Loop - by Daniel Bingamon - 12-06-2020, 06:23 PM

RE: 48-230 Antenna Loop - by Radioroslyn - 12-06-2020, 08:17 PM

48-230 Weak Signal - by Daniel Bingamon - 11-29-2020, 08:43 PM

View a Printable Version

Users browsing this thread: 4 Guest(s)

Recent Posts
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM

Who's Online

There are currently 6324 online users. [Complete List]
» 1 Member(s) | 6323 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me