Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 620B Power Up Quirk
#12

Larry make sure the shield is on that 75 and that the wire to the grid cap is run inside the shield too or the radio will squeal!

Ron

Bendix 0626.      RCA 8BX5.   RCA T64
Philco 41-250.    Philco49-500
GE 201.             Philco 39-25
Motorola 61X13. Philco 46-42        Crosley 52TQ
Philco 37-116.    Philco 70
AK 35                Philco 46-350
Philco 620B.       Zenith Transoceanic B-600
Philco 60B.         Majestic 50
Philco 52-944.    AK 84


Messages In This Thread
Philco 620B Power Up Quirk - by LarryFS - 11-25-2020, 01:25 PM
RE: Philco 620B Power Up Quirk - by morzh - 11-25-2020, 01:44 PM
RE: Philco 620B Power Up Quirk - by Bill Bacco - 11-25-2020, 01:48 PM
RE: Philco 620B Power Up Quirk - by LarryFS - 11-25-2020, 02:38 PM
RE: Philco 620B Power Up Quirk - by morzh - 11-25-2020, 03:01 PM
RE: Philco 620B Power Up Quirk - by LarryFS - 11-25-2020, 04:17 PM
RE: Philco 620B Power Up Quirk - by morzh - 11-25-2020, 05:00 PM
RE: Philco 620B Power Up Quirk - by radio1 - 11-26-2020, 09:24 PM
RE: Philco 620B Power Up Quirk - by LarryFS - 11-27-2020, 11:30 AM
RE: Philco 620B Power Up Quirk - by Scott D - 12-09-2020, 07:40 PM
RE: Philco 620B Power Up Quirk - by LarryFS - 12-09-2020, 08:57 PM
RE: Philco 620B Power Up Quirk - by 462ron - 12-10-2020, 09:45 AM
RE: Philco 620B Power Up Quirk - by LarryFS - 12-10-2020, 12:09 PM
RE: Philco 620B Power Up Quirk - by Scott D - 12-11-2020, 03:32 PM
RE: Philco 620B Power Up Quirk - by Phlogiston - 12-11-2020, 08:02 PM
RE: Philco 620B Power Up Quirk - by Arran - 12-11-2020, 11:33 PM
RE: Philco 620B Power Up Quirk - by Arran - 12-11-2020, 11:40 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM

[-]
Who's Online
There are currently 6310 online users. [Complete List]
» 1 Member(s) | 6309 Guest(s)
Avatar

>