Model 60 fun

Thread Rating:

Model 60 fun

radio1
Member

Posts: 102
Threads: 13
Joined: May 2020
City: Clemmons State, Province, Country: NC

01-03-2021, 08:47 PM

Strange you get 45.3 vs 85, did you measure it unconnected? Check the feeding resistors again.

Find

« Next Oldest | Next Newest »

Messages In This Thread

Model 60 fun - by Simon Wa3uay - 01-03-2021, 06:55 PM

RE: Model 60 fun - by Radioroslyn - 01-03-2021, 08:15 PM

RE: Model 60 fun - by radio1 - 01-03-2021, 08:47 PM

RE: Model 60 fun - by n1ps - 01-03-2021, 08:50 PM

RE: Model 60 fun - by Radioroslyn - 01-03-2021, 11:03 PM

RE: Model 60 fun - by Simon Wa3uay - 01-04-2021, 10:45 AM

RE: Model 60 fun - by Simon Wa3uay - 01-14-2021, 07:00 PM

Users browsing this thread: 2 Guest(s)

Recent Posts
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM

Who's Online

There are currently 6337 online users. [Complete List]
» 1 Member(s) | 6336 Guest(s)