Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Interesting issue with 48-482
#6

Continued replacing caps. I've pretty much cleared up the FM issue. Check this out: it was actually the coupling cap between the volume control and the 7B6, which has virtually no voltage on it, plus the bass and treble caps, which really have no voltage on them at all. Almost finished with cap replacement, then I'll check high value resistors that have a tendency to drift to twice or more of their rated values.

The FM on this set, now that it's stabilized (doesn't even have too bad of a drift problem!) turns out to be really quite sensitive, better than many of my more modern sets.


Messages In This Thread
Interesting issue with 48-482 - by BrendaAnnD - 01-03-2021, 08:56 AM
RE: Interesting issue with 48-482 - by RodB - 01-03-2021, 10:27 AM
RE: Interesting issue with 48-482 - by BrendaAnnD - 01-03-2021, 11:00 AM
RE: Interesting issue with 48-482 - by RodB - 01-03-2021, 11:55 AM
RE: Interesting issue with 48-482 - by morzh - 01-03-2021, 12:30 PM
RE: Interesting issue with 48-482 - by BrendaAnnD - 01-10-2021, 10:35 AM
RE: Interesting issue with 48-482 - by morzh - 01-10-2021, 01:18 PM
RE: Interesting issue with 48-482 - by BrendaAnnD - 01-10-2021, 06:51 PM
RE: Interesting issue with 48-482 - by morzh - 01-10-2021, 10:42 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 3061 online users. [Complete List]
» 1 Member(s) | 3060 Guest(s)
Avatar

>