Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Interesting issue with 48-482
#11

I only replace tubes if they test really weak. Even the borderline ones I keep.
I test them all, never relying on "maybe it's good".
In the current radio one tube has shorts, and two are very weak, so I bothered Bob Dobush. Speaking of which, I still have not received the tubes, so he gotta be looking for some.
I am yet to see a good paper cap. They are 100% leaky and 100% go up in value.
American ones are typically 50-100% up in value; the German ones I replace in Grundig are 300-400% up in value. Superbad.

Resistors....if they are not more than 10-15% up, I keep them, after all if they survived well, why change. More that that - I replace them.

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.


Messages In This Thread
Interesting issue with 48-482 - by BrendaAnnD - 01-03-2021, 08:56 AM
RE: Interesting issue with 48-482 - by RodB - 01-03-2021, 10:27 AM
RE: Interesting issue with 48-482 - by BrendaAnnD - 01-03-2021, 11:00 AM
RE: Interesting issue with 48-482 - by RodB - 01-03-2021, 11:55 AM
RE: Interesting issue with 48-482 - by morzh - 01-03-2021, 12:30 PM
RE: Interesting issue with 48-482 - by BrendaAnnD - 01-10-2021, 10:35 AM
RE: Interesting issue with 48-482 - by morzh - 01-10-2021, 01:18 PM
RE: Interesting issue with 48-482 - by BrendaAnnD - 01-10-2021, 06:51 PM
RE: Interesting issue with 48-482 - by morzh - 01-10-2021, 10:42 PM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 6818 online users. [Complete List]
» 2 Member(s) | 6816 Guest(s)
AvatarAvatar

>