Philco E976

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco E976

vecher
Phorum Expert

Posts: 933
Threads: 140
Joined: Mar 2015
City: Lansdale State, Province, Country: PA

01-14-2021, 12:04 PM

ALL, this has a old type rectifier.. I want to replace it.. I will use a 1N5408 ..what value of resistor do i need with it..

[Image: https://live.staticflickr.com/65535/5083...fd89_c.jpg]

Schemati

[Image: https://live.staticflickr.com/65535/5083...1798_c.jpg]

2nd Question is What can In use for the 2 caps on the AC line? they are .004 uf

i have a y2 cap -0047 and a x2 cap .0047 can i use either of these?

thanks
Skip

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco E976 - by vecher - 01-14-2021, 12:04 PM

RE: Philco E976 - by Radioroslyn - 01-14-2021, 04:06 PM

RE: Philco E976 - by RodB - 01-14-2021, 04:09 PM

View a Printable Version

Users browsing this thread: 3 Guest(s)

Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

Who's Online

There are currently 6568 online users. [Complete List]
» 1 Member(s) | 6567 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me