Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Another aqusition a Model 20
#14

Could be, I'll pull out the old Triplett 630. I get so use to using what ever is handy on the bench. The digital meters are great for ohm measurements. But like you say sometimes they be confusing or can be confused by hv with any sort of rf signal. Not in this case but have done some tv work where a vom is the only way to get accurate readings.
Tnx
Terry

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry


Messages In This Thread
Another aqusition a Model 20 - by 7estatdef - 02-26-2011, 06:00 PM
Re: Another aqusition - by TA Forbes - 02-27-2011, 12:00 AM
Re: Another aqusition - by 7estatdef - 02-27-2011, 08:31 AM
Re: Another aqusition - by TA Forbes - 02-27-2011, 01:07 PM
Re: Another aqusition - by 7estatdef - 02-27-2011, 02:26 PM
Re: Another aqusition - by 7estatdef - 02-28-2011, 08:15 PM
Re: Another aqusition - by 7estatdef - 02-28-2011, 09:22 PM
Re: Another aqusition - by 7estatdef - 03-01-2011, 08:22 AM
Re: Another aqusition - by 7estatdef - 03-01-2011, 10:01 PM
Re: Another aqusition a Model 20 - by 7estatdef - 03-02-2011, 10:06 PM
Re: Another aqusition a Model 20 - by Ron Ramirez - 03-03-2011, 07:48 AM
Re: Another aqusition a Model 20 - by 7estatdef - 03-17-2011, 04:51 PM
Re: Another aqusition a Model 20 - by codefox1 - 03-18-2011, 09:36 AM
Re: Another aqusition a Model 20 - by 7estatdef - 03-18-2011, 04:44 PM
Re: Another aqusition a Model 20 - by 7estatdef - 03-18-2011, 06:04 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently 2535 online users. [Complete List]
» 2 Member(s) | 2533 Guest(s)
AvatarAvatar

>