|
Help to id Philco condenser block
03-19-2011, 05:54 PM
If that resistor is like 1K it's going to apply a lot of grid bias this will lower the volume.
Terry When my pals were reading comic books I was down in the basement in my dad's workshop. Perusing his Sam's Photofoacts Vol 1-50 admiring the old set and trying to figure out what all those squiggly meant. Circa 1966 Now I think I've got! Terry
« Next Oldest | Next Newest »
Messages In This Thread
Help to id Philco condenser block - by Kico - 03-17-2011, 04:53 PM
Re: Help to id Philco condenser block - by gvel - 03-17-2011, 05:19 PM
Re: Help to id Philco condenser block - by Ron Ramirez - 03-17-2011, 06:27 PM
Re: Help to id Philco condenser block - by Kico - 03-17-2011, 09:09 PM
Re: Help to id Philco condenser block - by 7estatdef - 03-18-2011, 05:30 PM
Re: Help to id Philco condenser block - by planigan - 03-18-2011, 10:23 PM
Re: Help to id Philco condenser block - by Kico - 03-19-2011, 07:31 AM
Re: Help to id Philco condenser block - by gvel - 03-19-2011, 09:36 AM
Re: Help to id Philco condenser block - by Kico - 03-19-2011, 10:09 AM
Re: Help to id Philco condenser block - by 7estatdef - 03-19-2011, 02:03 PM
Re: Help to id Philco condenser block - by Kico - 03-19-2011, 04:15 PM
Re: Help to id Philco condenser block - by 7estatdef - 03-19-2011, 05:54 PM
Re: Help to id Philco condenser block - by planigan - 03-20-2011, 01:29 AM
Re: Help to id Philco condenser block - by exray - 03-20-2011, 05:58 AM
Re: Help to id Philco condenser block - by Kico - 03-20-2011, 07:38 AM
Re: Help to id Philco condenser block - by 7estatdef - 03-20-2011, 01:44 PM
Re: Help to id Philco condenser block - by planigan - 03-20-2011, 10:08 PM
Re: Help to id Philco condenser block - by Kico - 03-22-2011, 03:39 PM
Users browsing this thread: 1 Guest(s) |
