1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Phico 38-40 antenna coil
GaryK
Junior Member
**
Posts: 7
Threads: 1
Joined: Jan 2021
City: LOTT State, Province, Country: TX
#13

02-10-2021, 03:26 PM
So i removed the range 2 antenna coil that i had tacked in. The radio seems to be working great with just range 1. The volumn was a little low and after many hours of snooping around, i found a 500ohm resistor that should have been 500K ohm. It went to the screen of the output, 6G6. That was my mistake. Thanks.
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
Phico 38-40 antenna coil - by GaryK - 01-22-2021, 08:32 PM
RE: Phico 38-40 antenna coil - by rfeenstra - 01-23-2021, 01:36 AM
RE: Phico 38-40 antenna coil - by GaryK - 01-23-2021, 02:41 PM
RE: Phico 38-40 antenna coil - by radio1 - 01-26-2021, 10:46 PM
RE: Phico 38-40 antenna coil - by rfeenstra - 01-26-2021, 11:46 PM
RE: Phico 38-40 antenna coil - by GaryK - 01-27-2021, 12:31 PM
RE: Phico 38-40 antenna coil - by GaryK - 01-27-2021, 12:41 PM
RE: Phico 38-40 antenna coil - by rfeenstra - 01-27-2021, 01:25 PM
RE: Phico 38-40 antenna coil - by 462ron - 01-28-2021, 08:47 AM
RE: Phico 38-40 antenna coil - by GaryK - 01-28-2021, 10:49 AM
RE: Phico 38-40 antenna coil - by radio1 - 01-28-2021, 07:56 PM
RE: Phico 38-40 antenna coil - by GaryK - 01-28-2021, 11:31 PM
RE: Phico 38-40 antenna coil - by GaryK - 02-10-2021, 03:26 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Need to purchase some accessories for restoration of my Old Philco Radio
Hi Paulo, Welcome to the Philco Phorum. I can see why you want to find good reproduction parts. That is a bea...MrFixr55 — 11:10 PM
HiFi (Chifi) tube amp build - but my own design.
Tim, I have some bakelite sockets in my work shop that I can dig up. I believe quite a few are NOS. I will take photo...RodB — 10:03 PM
Philco 610B oscillator wiring
> The cathode as noted is wired directly to the ground side of the heater filament for that tube, not to the #17 and ...Radioroslyn — 08:12 PM
HiFi (Chifi) tube amp build - but my own design.
Tim; I noticed your post a little late, but I would take one of the junk sockets and try to break a chunk out of it wi...Arran — 08:07 PM
Need to purchase some accessories for restoration of my Old Philco Radio
Here is a list of resources found in our online library that you might find useful. Mike's Gobs of Knobs email addres...klondike98 — 01:46 PM
First Radio restoration
Hi Tubeman, Welcome to the Philco Phorum.  Phamily Phriendly Pfun with Phine Pholks Phull of Philco Phacts. (See a p...MrFixr55 — 12:33 PM
First Radio restoration
You could post in the WANTED ADs section here on the Phorum and see if anyone has an RF generator that they want to sell...klondike98 — 11:55 AM
Zenith H725
Good ideas, thank you Arrange and Rich. I have the adhesive aluminum foil already and can try that immediately. More ...EdHolland — 10:18 AM
Graphics for majestic 1050 dial glass.
Murf; I found this thread on the ARF, the first photo has a pretty good view of the dial glass. Regards ArranArran — 01:12 AM
Zenith H725
hello Ed, how about that speacial tape used for ducting it's like foil or how about thin piece of aluminum roof flash...radiorich — 12:19 AM

[-]
Who's Online
There are currently 1470 online users. [Complete List]
» 3 Member(s) | 1467 Guest(s)
AvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration