1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
First Resto - Philco 60B
LDel
Junior Member
**
Posts: 21
Threads: 1
Joined: Feb 2021
City: La Baie State, Province, Country: Québec
#22

02-11-2021, 04:09 PM
Partial success:  I can now pass a 460 KC Cycle.  The problem:  An intermittent short in one of the signal generator leads!!!  Do I feel stupid?  Yep!  Is my face beet red?  Definitely!!!  The IF's are now aligned, but still can't receive any stations - One baby step at a time!
Find
« Next Oldest | Next Newest »


Messages In This Thread
First Resto - Philco 60B - by LDel - 02-06-2021, 02:39 PM
RE: First Resto - Philco 60B - by Ron Ramirez - 02-06-2021, 02:53 PM
RE: First Resto - Philco 60B - by Radioroslyn - 02-06-2021, 06:58 PM
RE: First Resto - Philco 60B - by LDel - 02-06-2021, 07:35 PM
RE: First Resto - Philco 60B - by Radioroslyn - 02-06-2021, 11:45 PM
RE: First Resto - Philco 60B - by fenbach - 02-07-2021, 01:00 AM
RE: First Resto - Philco 60B - by LDel - 02-07-2021, 08:28 AM
RE: First Resto - Philco 60B - by LDel - 02-07-2021, 08:29 AM
RE: First Resto - Philco 60B - by Radioroslyn - 02-07-2021, 11:19 AM
RE: First Resto - Philco 60B - by LDel - 02-07-2021, 12:57 PM
RE: First Resto - Philco 60B - by LDel - 02-07-2021, 10:31 PM
RE: First Resto - Philco 60B - by Radioroslyn - 02-07-2021, 11:47 PM
RE: First Resto - Philco 60B - by mikethedruid - 02-07-2021, 11:56 PM
RE: First Resto - Philco 60B - by LDel - 02-08-2021, 01:41 PM
RE: First Resto - Philco 60B - by LDel - 02-08-2021, 02:04 PM
RE: First Resto - Philco 60B - by mikethedruid - 02-08-2021, 02:04 PM
RE: First Resto - Philco 60B - by LDel - 02-08-2021, 02:09 PM
RE: First Resto - Philco 60B - by LDel - 02-08-2021, 03:50 PM
RE: First Resto - Philco 60B - by Radioroslyn - 02-08-2021, 05:21 PM
RE: First Resto - Philco 60B - by LDel - 02-08-2021, 06:07 PM
RE: First Resto - Philco 60B - by LDel - 02-08-2021, 07:14 PM
RE: First Resto - Philco 60B - by LDel - 02-11-2021, 04:09 PM
RE: First Resto - Philco 60B - by Radioroslyn - 02-11-2021, 05:37 PM
RE: First Resto - Philco 60B - by LDel - 02-16-2021, 10:45 AM
RE: First Resto - Philco 60B - by fenbach - 02-16-2021, 03:59 PM
RE: First Resto - Philco 60B - by LDel - 02-16-2021, 04:44 PM
RE: First Resto - Philco 60B - by Radioroslyn - 02-16-2021, 05:02 PM
RE: First Resto - Philco 60B - by LDel - 02-16-2021, 05:37 PM
RE: First Resto - Philco 60B - by LDel - 02-24-2021, 04:33 PM
RE: First Resto - Philco 60B - by RodB - 02-24-2021, 05:42 PM
RE: First Resto - Philco 60B - by LDel - 02-24-2021, 05:47 PM
RE: First Resto - Philco 60B - by LDel - 03-06-2021, 04:46 PM
RE: First Resto - Philco 60B - by Radioroslyn - 03-06-2021, 05:52 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM
IF can wire size and Rubber mounts?
A pair of wire strippers can give you an idea of what the existing gauge of the wire leads are in the IF can, I think it...Arran — 06:07 AM
My last cabinet for this year
Hello Dan, That is really beautiful what great looking radio you have ! I have friends who live in Calgary and the wea...radiorich — 01:51 AM

[-]
Who's Online
There are currently 4505 online users. [Complete List]
» 3 Member(s) | 4502 Guest(s)
AvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration