Philco 43 - Filter Choke

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco 43 - Filter Choke

Masonparker
Junior Member

Posts: 47
Threads: 10
Joined: Nov 2020
City: CHESAPEAKE State, Province, Country: VA

02-21-2021, 08:08 PM

The new choke came in added the resistor to get to the 2100 ohm changed the two condensers to 30 mfd (didn't have a 47). Powered up the radio and the hum is gone but no sound. So I started to check voltages. The voltage at the rectifier checked out - F-F was 4.65V and voltage at each plates were 349V and 347V . I check the voltage across the center tap and it was reading 350V on each side. All the filament voltage at all the tubes were good. But I have no voltage at any of the plates. Any thoughts what i should try next???

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 43 - Filter Choke - by Masonparker - 02-13-2021, 06:16 PM

RE: Philco 43 - Filter Choke - by Radioroslyn - 02-13-2021, 06:43 PM

RE: Philco 43 - Filter Choke - by morzh - 02-13-2021, 09:07 PM

RE: Philco 43 - Filter Choke - by Masonparker - 02-21-2021, 08:08 PM

RE: Philco 43 - Filter Choke - by Radioroslyn - 02-21-2021, 08:49 PM

RE: Philco 43 - Filter Choke - by morzh - 02-21-2021, 10:43 PM

RE: Philco 43 - Filter Choke - by Masonparker - 02-22-2021, 09:14 PM

RE: Philco 43 - Filter Choke - by morzh - 02-22-2021, 10:06 PM

RE: Philco 43 - Filter Choke - by Masonparker - 02-22-2021, 10:12 PM

RE: Philco 43 - Filter Choke - by Masonparker - 02-22-2021, 10:15 PM

RE: Philco 43 - Filter Choke - by Masonparker - 02-22-2021, 10:59 PM

RE: Philco 43 - Filter Choke - by morzh - 02-22-2021, 11:22 PM

RE: Philco 43 - Filter Choke - by Masonparker - 02-23-2021, 07:58 PM

RE: Philco 43 - Filter Choke - by Radioroslyn - 02-23-2021, 08:36 PM

RE: Philco 43 - Filter Choke - by Masonparker - 03-18-2021, 06:52 PM

RE: Philco 43 - Filter Choke - by Radioroslyn - 03-18-2021, 07:12 PM

RE: Philco 43 - Filter Choke - by Masonparker - 03-19-2021, 06:44 PM

RE: Philco 43 - Filter Choke - by Masonparker - 03-19-2021, 06:49 PM

RE: Philco 43 - Filter Choke - by Masonparker - 03-19-2021, 07:13 PM

RE: Philco 43 - Filter Choke - by Radioroslyn - 03-19-2021, 10:24 PM

RE: Philco 43 - Filter Choke - by morzh - 03-19-2021, 11:06 PM

RE: Philco 43 - Filter Choke - by Masonparker - 03-20-2021, 08:34 PM

RE: Philco 43 - Filter Choke - by morzh - 03-20-2021, 09:37 PM

RE: Philco 43 - Filter Choke - by Masonparker - 03-21-2021, 09:42 AM

RE: Philco 43 - Filter Choke - by morzh - 03-21-2021, 12:05 PM

RE: Philco 43 - Filter Choke - by Masonparker - 04-10-2021, 10:47 AM

RE: Philco 43 - Filter Choke - by Radioroslyn - 04-10-2021, 01:56 PM

View a Printable Version

Users browsing this thread: 3 Guest(s)

Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone, Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

Who's Online

There are currently 5187 online users. [Complete List]
» 1 Member(s) | 5186 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me