Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 40-180 Chassis Restore
#42

Thanks all! I did clean all sockets using a small dental brush and Deoxit D5. I just sprayed a little on the brush, cleaned each socket pin, and let it dry while I worked on other stuff. Actually, everything had over a week to dry. For the tubes themselves, all of the original tubes but one tested bad, and I ended up replacing them. The 7B7 had one pin that was visibly dirty so just went over all the pins very very lightly with a small piece of dry Scotch Brite pad. Seemed to do the trick!

Vinny
Greensburg, IN

"We don't care what you do...just don't electrocute yourself or burn the house down."
-My Parents


Messages In This Thread
Philco 40-180 Chassis Restore - by unclevinny86 - 02-15-2021, 08:28 PM
RE: Philco 40-180 Chassis Restore - by rfeenstra - 02-19-2021, 11:26 PM
RE: Philco 40-180 Chassis Restore - by morzh - 02-21-2021, 02:03 PM
RE: Philco 40-180 Chassis Restore - by rfeenstra - 02-21-2021, 02:23 PM
RE: Philco 40-180 Chassis Restore - by 462ron - 02-22-2021, 07:56 AM
RE: Philco 40-180 Chassis Restore - by morzh - 02-22-2021, 09:32 AM
RE: Philco 40-180 Chassis Restore - by morzh - 02-27-2021, 01:46 PM
RE: Philco 40-180 Chassis Restore - by Arran - 03-09-2021, 11:09 PM
RE: Philco 40-180 Chassis Restore - by RodB - 03-10-2021, 09:11 AM
RE: Philco 40-180 Chassis Restore - by morzh - 03-14-2021, 09:48 PM
RE: Philco 40-180 Chassis Restore - by tbone - 03-15-2021, 07:03 PM
RE: Philco 40-180 Chassis Restore - by OZ4 - 03-15-2021, 08:32 PM
RE: Philco 40-180 Chassis Restore - by morzh - 03-22-2021, 09:24 PM
RE: Philco 40-180 Chassis Restore - by unclevinny86 - 03-22-2021, 09:38 PM



Users browsing this thread: 2 Guest(s)