Mdl 70B hardware help

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Mdl 70B hardware help

Steve Davis
Phorum Expert

Posts: 1,402
Threads: 70
Joined: Oct 2007
City: Linn Creek, MO

03-24-2021, 05:58 PM

Terry, the 70 used three wood screws, I think 10x1 but might be 8x1. There is one screw in the top and one on each side, none in the bottom. The front side of the front panel has a counter bore at each of these screws holes with a Tinnerman speed nut to support the speaker. The screws pass through the speed nuts and screw into the front arch.

Steve

M R Radios C M Tubes

Find

« Next Oldest | Next Newest »

Messages In This Thread

Mdl 70B hardware help - by Radioroslyn - 03-24-2021, 04:28 PM

RE: Mdl 70B hardware help - by Steve Davis - 03-24-2021, 05:58 PM

RE: Mdl 70B hardware help - by Radioroslyn - 03-24-2021, 06:30 PM

RE: Mdl 70B hardware help - by Steve Davis - 03-24-2021, 06:36 PM

View a Printable Version

Users browsing this thread:

Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic. As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

Who's Online

There are currently 1732 online users. [Complete List]
» 2 Member(s) | 1730 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me