Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Newbie... Philco Show & Tell
#5

I'm sure I've had t he AR-88 fired up. I understand that most of them went to England and Canada. Any guy who has one is a lucky pup. Yes, I also have the ACR-175. RCA did a nice job on their communications receivers, but the hams gravitated toward Hallicrafters, Hammarlund and National. That pretty much took all the steam out of RCA's efforts.

When I was a kid, and saw the Halli SX-28's in the stores, then one in a pal's home, I'd have heart palpitations. I do have a SX-28, and the bass reflex speaker. My first communications set was a Halli SX-62. It was my set in the dorm where I lived in college. It was in the Upper Peninsula of Michigan, and if you didn't have something like that, you were limited to about 2 stations. I st ill have that set, of course.


Messages In This Thread
Newbie... Philco Show & Tell - by hbogie - 04-02-2011, 05:05 PM
Re: Newbie... Philco Show & Tell - by hbogie - 04-02-2011, 05:11 PM
Re: Newbie... Philco Show & Tell - by hbogie - 04-02-2011, 08:34 PM
Re: Newbie... Philco Show & Tell - by Doug Houston - 04-02-2011, 10:17 PM
Re: Newbie... Philco Show & Tell - by TA Forbes - 04-05-2011, 11:25 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM
Philco 16B Parts
Hi Dan, Mike is correct, there's a lot of painted stuff on the chassis but it looks pretty good. The sm is all there,sp...Radioroslyn — 03:50 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Hi Cap'n Clock, Unfortunately, I do not have this radio.  This is a shame because this should be a good performer.  2A...captainclock1988 — 03:43 PM

[-]
Who's Online
There are currently 3042 online users. [Complete List]
» 1 Member(s) | 3041 Guest(s)
Avatar

>