1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
New member with 37-650 Questions
mikethedruid
Banned
Posts: 1,824
Threads: 114
Joined: Jul 2014
City: Sneedville, TN
#30

04-01-2021, 09:59 PM
Also, what's with the safety caps on the outside of the bakelite block? To replace the caps in that bakelite block you have to REMOVE the old ones inside it. That is done by heating the block in an oven at about 250F until the resin inside melts out, then pulling out the guts, then replacing the guts INSIDE with the two safety caps. If you don't remove the old ones inside they can still short and form a shock hazard to the chassis.
Find
« Next Oldest | Next Newest »


Messages In This Thread
New member with 37-650 Questions - by Chinook47 - 03-22-2021, 12:00 AM
RE: New member - by Eliot Ness - 03-22-2021, 12:34 PM
RE: New member - by klondike98 - 03-22-2021, 02:03 PM
RE: New member - by David - 03-22-2021, 02:15 PM
RE: New member - by Steve Davis - 03-22-2021, 03:02 PM
RE: New member - by morzh - 03-22-2021, 03:52 PM
RE: New member - by Radioroslyn - 03-22-2021, 04:26 PM
RE: New member with 37-650 Questions - by Chas - 03-23-2021, 05:23 PM
RE: New member with 37-650 Questions - by OZ4 - 03-24-2021, 12:23 PM
RE: New member with 37-650 Questions - by OZ4 - 03-24-2021, 09:37 PM
RE: New member with 37-650 Questions - by OZ4 - 03-24-2021, 10:15 PM
RE: New member with 37-650 Questions - by OZ4 - 03-30-2021, 04:00 PM
RE: New member with 37-650 Questions - by morzh - 03-30-2021, 04:09 PM
RE: New member with 37-650 Questions - by OZ4 - 03-31-2021, 10:44 AM
RE: New member with 37-650 Questions - by OZ4 - 04-01-2021, 08:58 PM
RE: New member with 37-650 Questions - by mikethedruid - 04-01-2021, 09:59 PM
RE: New member with 37-650 Questions - by OZ4 - 04-02-2021, 10:21 AM
RE: New member with 37-650 Questions - by OZ4 - 04-02-2021, 06:53 PM
RE: New member with 37-650 Questions - by tbone - 04-02-2021, 09:56 PM
RE: New member with 37-650 Questions - by OZ4 - 04-02-2021, 10:02 PM
RE: New member with 37-650 Questions - by tbone - 04-03-2021, 08:23 AM
RE: New member with 37-650 Questions - by tbone - 04-03-2021, 10:06 AM
RE: New member with 37-650 Questions - by OZ4 - 04-03-2021, 12:19 PM
RE: New member with 37-650 Questions - by tbone - 04-03-2021, 04:03 PM
RE: New member with 37-650 Questions - by OZ4 - 04-03-2021, 07:09 PM
RE: New member with 37-650 Questions - by OZ4 - 04-05-2021, 10:24 PM
RE: New member with 37-650 Questions - by OZ4 - 04-05-2021, 11:58 PM
RE: New member with 37-650 Questions - by tbone - 04-09-2021, 07:58 PM
RE: New member with 37-650 Questions - by tbone - 04-11-2021, 01:10 PM
RE: New member with 37-650 Questions - by David - 04-11-2021, 05:34 PM



Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM
IF can wire size and Rubber mounts?
A pair of wire strippers can give you an idea of what the existing gauge of the wire leads are in the IF can, I think it...Arran — 06:07 AM
My last cabinet for this year
Hello Dan, That is really beautiful what great looking radio you have ! I have friends who live in Calgary and the wea...radiorich — 01:51 AM

[-]
Who's Online
There are currently 4474 online users. [Complete List]
» 4 Member(s) | 4470 Guest(s)
AvatarAvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration