New member with 37-650 Questions

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

New member with 37-650 Questions

Chinook47
Junior Member

Posts: 23
Threads: 2
Joined: Mar 2021
City: Philadelphia State, Province, Country: Pa

#41

04-03-2021, 11:01 AM

Thank you Tony for all the suggestions. I didnt see your response from earlier asking for the values. No worries on the questions too, I appreciate any help or suggestions. Everyone in this forum has been extremely helpful. The only resistance I measured at this point was across R58 at 137ohms. I will probably respond back tomorrow or so with the values your asking. Also, the speaker is plugged in when I'm taking these readings.

Thank you again for your time and suggestions.

Find

« Next Oldest | Next Newest »

Messages In This Thread

New member with 37-650 Questions - by Chinook47 - 03-22-2021, 12:00 AM

RE: New member - by Eliot Ness - 03-22-2021, 12:34 PM

RE: New member - by klondike98 - 03-22-2021, 02:03 PM

RE: New member - by David - 03-22-2021, 02:15 PM

RE: New member - by Steve Davis - 03-22-2021, 03:02 PM

RE: New member - by morzh - 03-22-2021, 03:52 PM

RE: New member - by Radioroslyn - 03-22-2021, 04:26 PM

RE: New member with 37-650 Questions - by Ron Ramirez - 03-22-2021, 04:30 PM

RE: New member with 37-650 Questions - by klondike98 - 03-22-2021, 05:18 PM

RE: New member with 37-650 Questions - by Chinook47 - 03-22-2021, 08:53 PM

RE: New member with 37-650 Questions - by Radioroslyn - 03-22-2021, 09:41 PM

RE: New member with 37-650 Questions - by Chas - 03-23-2021, 05:23 PM

RE: New member with 37-650 Questions - by klondike98 - 03-23-2021, 07:55 PM

RE: New member with 37-650 Questions - by Steve Davis - 03-24-2021, 10:47 AM

RE: New member with 37-650 Questions - by OZ4 - 03-24-2021, 12:23 PM

RE: New member with 37-650 Questions - by Chinook47 - 03-24-2021, 08:41 PM

RE: New member with 37-650 Questions - by OZ4 - 03-24-2021, 09:37 PM

RE: New member with 37-650 Questions - by OZ4 - 03-24-2021, 10:15 PM

RE: New member with 37-650 Questions - by Chinook47 - 03-24-2021, 10:54 PM

RE: New member with 37-650 Questions - by Radioroslyn - 03-24-2021, 11:24 PM

RE: New member with 37-650 Questions - by Chinook47 - 03-30-2021, 02:56 PM

RE: New member with 37-650 Questions - by OZ4 - 03-30-2021, 04:00 PM

RE: New member with 37-650 Questions - by morzh - 03-30-2021, 04:09 PM

RE: New member with 37-650 Questions - by Chinook47 - 03-30-2021, 11:07 PM

RE: New member with 37-650 Questions - by OZ4 - 03-31-2021, 10:44 AM

RE: New member with 37-650 Questions - by Chinook47 - 03-31-2021, 07:59 PM

RE: New member with 37-650 Questions - by Chinook47 - 03-31-2021, 08:07 PM

RE: New member with 37-650 Questions - by Chinook47 - 03-31-2021, 08:09 PM

RE: New member with 37-650 Questions - by OZ4 - 04-01-2021, 08:58 PM

RE: New member with 37-650 Questions - by mikethedruid - 04-01-2021, 09:59 PM

RE: New member with 37-650 Questions - by Chinook47 - 04-01-2021, 10:28 PM

RE: New member with 37-650 Questions - by OZ4 - 04-02-2021, 10:21 AM

RE: New member with 37-650 Questions - by Chinook47 - 04-02-2021, 04:03 PM

RE: New member with 37-650 Questions - by Chinook47 - 04-02-2021, 06:36 PM

RE: New member with 37-650 Questions - by OZ4 - 04-02-2021, 06:53 PM

RE: New member with 37-650 Questions - by tbone - 04-02-2021, 09:56 PM

RE: New member with 37-650 Questions - by OZ4 - 04-02-2021, 10:02 PM

RE: New member with 37-650 Questions - by tbone - 04-03-2021, 08:23 AM

RE: New member with 37-650 Questions - by Chinook47 - 04-03-2021, 09:32 AM

RE: New member with 37-650 Questions - by tbone - 04-03-2021, 10:06 AM

RE: New member with 37-650 Questions - by Chinook47 - 04-03-2021, 11:01 AM

RE: New member with 37-650 Questions - by OZ4 - 04-03-2021, 12:19 PM

RE: New member with 37-650 Questions - by tbone - 04-03-2021, 04:03 PM

RE: New member with 37-650 Questions - by OZ4 - 04-03-2021, 07:09 PM

RE: New member with 37-650 Questions - by Chinook47 - 04-05-2021, 08:14 PM

RE: New member with 37-650 Questions - by OZ4 - 04-05-2021, 10:24 PM

RE: New member with 37-650 Questions - by Chinook47 - 04-05-2021, 10:42 PM

RE: New member with 37-650 Questions - by Chinook47 - 04-05-2021, 10:44 PM

RE: New member with 37-650 Questions - by Chinook47 - 04-05-2021, 11:06 PM

RE: New member with 37-650 Questions - by OZ4 - 04-05-2021, 11:58 PM

RE: New member with 37-650 Questions - by Chinook47 - 04-06-2021, 11:38 AM

RE: New member with 37-650 Questions - by tbone - 04-09-2021, 07:58 PM

RE: New member with 37-650 Questions - by Chinook47 - 04-10-2021, 07:09 AM

RE: New member with 37-650 Questions - by tbone - 04-11-2021, 01:10 PM

RE: New member with 37-650 Questions - by mikethedruid - 04-11-2021, 02:30 PM

RE: New member with 37-650 Questions - by Chinook47 - 04-11-2021, 04:55 PM

RE: New member with 37-650 Questions - by David - 04-11-2021, 05:34 PM

View a Printable Version

Users browsing this thread: 3 Guest(s)

Recent Posts
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM
IF can wire size and Rubber mounts?
A pair of wire strippers can give you an idea of what the existing gauge of the wire leads are in the IF can, I think it...Arran — 06:07 AM
My last cabinet for this year
Hello Dan, That is really beautiful what great looking radio you have ! I have friends who live in Calgary and the wea...radiorich — 01:51 AM

Who's Online

There are currently 4432 online users. [Complete List]
» 2 Member(s) | 4430 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me