1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
New member with 37-650 Questions
Chinook47
Junior Member
**
Posts: 23
Threads: 2
Joined: Mar 2021
City: Philadelphia State, Province, Country: Pa
#49

04-05-2021, 11:06 PM
I appreciate all the help. I think I will send this radio to the shop or the deep six. I got into the hobby cause I do woodworking and a local shop was going to charge me $1700 starting for recapping. I was pretty fortunate to restore my zenith chassis and cabinet however this chassis seems to have some demons. However, I have learned alot more.

Thank you all again for putting in the time to troubleshoot.
Find
« Next Oldest | Next Newest »


Messages In This Thread
New member with 37-650 Questions - by Chinook47 - 03-22-2021, 12:00 AM
RE: New member - by Eliot Ness - 03-22-2021, 12:34 PM
RE: New member - by klondike98 - 03-22-2021, 02:03 PM
RE: New member - by David - 03-22-2021, 02:15 PM
RE: New member - by Steve Davis - 03-22-2021, 03:02 PM
RE: New member - by morzh - 03-22-2021, 03:52 PM
RE: New member - by Radioroslyn - 03-22-2021, 04:26 PM
RE: New member with 37-650 Questions - by Chas - 03-23-2021, 05:23 PM
RE: New member with 37-650 Questions - by OZ4 - 03-24-2021, 12:23 PM
RE: New member with 37-650 Questions - by OZ4 - 03-24-2021, 09:37 PM
RE: New member with 37-650 Questions - by OZ4 - 03-24-2021, 10:15 PM
RE: New member with 37-650 Questions - by OZ4 - 03-30-2021, 04:00 PM
RE: New member with 37-650 Questions - by morzh - 03-30-2021, 04:09 PM
RE: New member with 37-650 Questions - by OZ4 - 03-31-2021, 10:44 AM
RE: New member with 37-650 Questions - by OZ4 - 04-01-2021, 08:58 PM
RE: New member with 37-650 Questions - by OZ4 - 04-02-2021, 10:21 AM
RE: New member with 37-650 Questions - by OZ4 - 04-02-2021, 06:53 PM
RE: New member with 37-650 Questions - by tbone - 04-02-2021, 09:56 PM
RE: New member with 37-650 Questions - by OZ4 - 04-02-2021, 10:02 PM
RE: New member with 37-650 Questions - by tbone - 04-03-2021, 08:23 AM
RE: New member with 37-650 Questions - by tbone - 04-03-2021, 10:06 AM
RE: New member with 37-650 Questions - by OZ4 - 04-03-2021, 12:19 PM
RE: New member with 37-650 Questions - by tbone - 04-03-2021, 04:03 PM
RE: New member with 37-650 Questions - by OZ4 - 04-03-2021, 07:09 PM
RE: New member with 37-650 Questions - by OZ4 - 04-05-2021, 10:24 PM
RE: New member with 37-650 Questions - by Chinook47 - 04-05-2021, 11:06 PM
RE: New member with 37-650 Questions - by OZ4 - 04-05-2021, 11:58 PM
RE: New member with 37-650 Questions - by tbone - 04-09-2021, 07:58 PM
RE: New member with 37-650 Questions - by tbone - 04-11-2021, 01:10 PM
RE: New member with 37-650 Questions - by David - 04-11-2021, 05:34 PM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM
IF can wire size and Rubber mounts?
A pair of wire strippers can give you an idea of what the existing gauge of the wire leads are in the IF can, I think it...Arran — 06:07 AM
My last cabinet for this year
Hello Dan, That is really beautiful what great looking radio you have ! I have friends who live in Calgary and the wea...radiorich — 01:51 AM

[-]
Who's Online
There are currently 5268 online users. [Complete List]
» 2 Member(s) | 5266 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration