GE S-22 electrolytic help

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

GE S-22 electrolytic help

Phil27
Junior Member

Posts: 46
Threads: 16
Joined: Dec 2020
City: Kingston State, Province, Country: Ontario

04-28-2021, 09:53 PM

http://www.radio-antiks.com/Design/Asset...-22/37.jpg

http://www.radio-antiks.com/Design/Asset...-22/32.jpg

These two above photos show what should be there and how the Mershons did have a screw threaded base with a nut. The last photo shows my radio. There is nothing there. I could put a terminal strip underneath but as I said I’m unsure of how to wire it correctly.

At a later time I could glue some empty caps to cover the holes to make it look better but my concern now is how to install the new caps.

Attached Files Image(s)

Find

« Next Oldest | Next Newest »

Messages In This Thread

GE S-22 electrolytic help - by Phil27 - 04-28-2021, 12:08 PM

RE: GE S-22 electrolytic help - by klondike98 - 04-28-2021, 07:23 PM

RE: GE S-22 electrolytic help - by Phlogiston - 04-28-2021, 07:56 PM

RE: GE S-22 electrolytic help - by mikethedruid - 04-28-2021, 08:22 PM

RE: GE S-22 electrolytic help - by Phil27 - 04-28-2021, 09:53 PM

RE: GE S-22 electrolytic help - by mikethedruid - 04-29-2021, 02:59 AM

RE: GE S-22 electrolytic help - by Phil27 - 04-29-2021, 10:12 AM

RE: GE S-22 electrolytic help - by Phil27 - 04-29-2021, 02:17 PM

RE: GE S-22 electrolytic help - by mikethedruid - 04-29-2021, 04:05 PM

RE: GE S-22 electrolytic help - by Phil27 - 04-29-2021, 05:27 PM

RE: GE S-22 electrolytic help - by Arran - 04-29-2021, 06:19 PM

RE: GE S-22 electrolytic help - by Phil27 - 05-03-2021, 10:02 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online

There are currently 4765 online users. [Complete List]
» 1 Member(s) | 4764 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me