Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 201X
#26

>Wow ! mice made a home in there... reminds me of the 37-640 I have never managed to finish. Ran into problems and put it aside until my disgust subsides. Good luck with the project. I enjoy a lot of pictures as you have shared. I'll watch out for the coming installments.<

I understand Mike, when I got this out and started looking it over, it quickly became apparent  that this was going to be a project. Apparently when the critter's sunflower seed supply dried up, it decided the cloth on the wire would do. He chewed  a bunch of the wire on the right side and others, Bare. Glade I read the many posts on this site about not plugging these in until checking them out.

The critter wasn't the only one in there, as you can see, someone must have had a supply of 8mf caps because they replaced everything that was bad with them, including what were only 1 & 2 mfs.

   


Messages In This Thread
Philco 201X - by bgorman - 05-10-2021, 09:49 PM
RE: Philco 201X - by Phlogiston - 05-10-2021, 10:17 PM
RE: Philco 201X - by morzh - 05-11-2021, 12:48 AM
RE: Philco 201X - by Nathan Slingerland - 05-11-2021, 11:56 AM
RE: Philco 201X - by bgorman - 05-11-2021, 07:09 PM
RE: Philco 201X - by morzh - 05-11-2021, 08:12 PM
RE: Philco 201X - by Phlogiston - 05-11-2021, 09:07 PM
RE: Philco 201X - by Patrick - 05-11-2021, 10:13 PM
RE: Philco 201X - by Phlogiston - 05-11-2021, 10:16 PM
RE: Philco 201X - by bgorman - 05-11-2021, 11:17 PM
RE: Philco 201X - by bgorman - 05-11-2021, 11:22 PM
RE: Philco 201X - by bgorman - 05-11-2021, 11:51 PM
RE: Philco 201X - by bgorman - 05-11-2021, 11:55 PM
RE: Philco 201X - by Patrick - 05-12-2021, 06:51 AM
RE: Philco 201X - by Radioroslyn - 05-12-2021, 09:24 AM
RE: Philco 201X - by bgorman - 05-12-2021, 11:37 PM
RE: Philco 201X - by bgorman - 05-13-2021, 12:07 AM
RE: Philco 201X - by bgorman - 05-13-2021, 12:27 AM
RE: Philco 201X - by Radioroslyn - 05-13-2021, 06:59 AM
RE: Philco 201X - by admin - 05-13-2021, 08:05 AM
RE: Philco 201X - by bgorman - 05-13-2021, 05:44 PM
RE: Philco 201X - by bgorman - 05-13-2021, 06:01 PM
RE: Philco 201X - by bgorman - 05-14-2021, 10:33 PM
RE: Philco 201X - by mikethedruid - 05-14-2021, 11:54 PM
RE: Philco 201X - by Radioroslyn - 05-15-2021, 04:45 AM
RE: Philco 201X - by bgorman - 05-16-2021, 03:34 PM
RE: Philco 201X - by Radioroslyn - 05-16-2021, 06:55 PM
RE: Philco 201X - by bgorman - 05-17-2021, 11:29 PM
RE: Philco 201X - by Radioroslyn - 05-18-2021, 05:39 PM
RE: Philco 201X - by bgorman - 05-19-2021, 05:44 PM
RE: Philco 201X - by Radioroslyn - 05-19-2021, 09:09 PM
RE: Philco 201X - by 462ron - 05-20-2021, 10:34 AM
RE: Philco 201X - by bgorman - 05-22-2021, 10:14 PM
RE: Philco 201X - by bgorman - 05-22-2021, 10:48 PM
RE: Philco 201X - by 462ron - 05-23-2021, 07:11 AM
RE: Philco 201X - by bgorman - 05-31-2021, 02:57 AM
RE: Philco 201X - by 462ron - 05-31-2021, 09:24 AM
RE: Philco 201X - by bgorman - 06-02-2021, 10:05 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM
IF can wire size and Rubber mounts?
A pair of wire strippers can give you an idea of what the existing gauge of the wire leads are in the IF can, I think it...Arran — 06:07 AM
My last cabinet for this year
Hello Dan, That is really beautiful what great looking radio you have ! I have friends who live in Calgary and the wea...radiorich — 01:51 AM

[-]
Who's Online
There are currently 5511 online users. [Complete List]
» 2 Member(s) | 5509 Guest(s)
AvatarAvatar

>