1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
chassis support bushings/pads
fenbach
Member
***
Posts: 140
Threads: 28
Joined: Dec 2016
City: portland, OR
#1

07-12-2021, 07:42 PM
i'm looking to replace the rubber [sometimes cork] bushings/pads that support the chassis. of a model 60 in my case. the rubber ones in the radio are 5/16" thick and not quite an inch in diameter. with a small hole for the lag-type screw that threads in from below. anyone know of a supplier? or what to ask for at the hardware store.
thanks.
Find
« Next Oldest | Next Newest »


Messages In This Thread
chassis support bushings/pads - by fenbach - 07-12-2021, 07:42 PM
RE: chassis support bushings/pads - by Patrick - 07-12-2021, 09:14 PM
RE: chassis support bushings/pads - by David - 07-13-2021, 12:17 PM
RE: chassis support bushings/pads - by Arran - 07-14-2021, 07:12 PM
RE: chassis support bushings/pads - by fenbach - 07-14-2021, 10:12 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Not sure if anyone has tried this but there are 6.3 volt miniature lamps in bayonet and screw-in base options available ...GarySP — 11:31 AM
Shadow Meter Bulb
Any 6.3 volt pilot light will work. I would use the brightest one I could find in my workroom. Be sure the dial is clean...RodB — 10:45 AM
HiFi (Chifi) tube amp build - but my own design.
Tim, nice write up and thanks for sharing !! Sincerely Richardradiorich — 02:47 AM
HiFi (Chifi) tube amp build - but my own design.
Well, this was a real "Hum-Dinger" :lol: ! This will be kinda long, but hopefully it will help others having t...TV MAN — 01:55 AM
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM

[-]
Who's Online
There are currently 7601 online users. [Complete List]
» 1 Member(s) | 7600 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios