Thread Rating:
  • 1 Vote(s) - 2 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 46-1201 Code 121
#5

I noticed you asked about getting the record player to play 45 RPM records. You're out of luck there. The 46-1201 predates the introduction of 45 RPM records by RCA in 1949. In fact, it predates the introduction of the 33 1/3 RPM LP records in 1948. The turntable on that record player only plays 78 RPM records.

Now, I do not recommend this, as it will seriously affect the value of the unit, but, since the motor in the 46-1201 is an AC motor which runs off the mains, you could probably put in a modern turntable as long as you fitted it with a high output cartridge. The purists here would be aghast, but it could be done. You would, of course, have to modify the cabinet inside to accommodate the new turntable also. That is the only way it could be done.


Messages In This Thread
Philco 46-1201 Code 121 - by ravenlee528 - 08-07-2021, 01:33 PM
RE: Philco 46-1201 Code 121 - by klondike98 - 08-07-2021, 01:56 PM
RE: Philco 46-1201 Code 121 - by mikethedruid - 08-07-2021, 02:41 PM
RE: Philco 46-1201 Code 121 - by morzh - 08-07-2021, 06:58 PM
RE: Philco 46-1201 Code 121 - by mikethedruid - 08-07-2021, 08:39 PM
RE: Philco 46-1201 Code 121 - by morzh - 08-07-2021, 10:08 PM
RE: Philco 46-1201 Code 121 - by mmcdac - 12-21-2023, 06:15 PM
RE: Philco 46-1201 Code 121 - by mmcdac - 12-24-2023, 10:38 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM

[-]
Who's Online
There are currently 5402 online users. [Complete List]
» 2 Member(s) | 5400 Guest(s)
AvatarAvatar

>