1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Mechanical OFF/ON indicator
Croydonradio
Junior Member
**
Posts: 9
Threads: 4
Joined: Jul 2021
City: Ottawa State, Province, Country: Ontario
#4

08-17-2021, 08:43 PM
Found the same radio on youtube, the cord makes a 3-point loop on the metal tab with a spring anchoring the one end of the cord, and the other end goes to the cam on the off/on switch.
Find
« Next Oldest | Next Newest »


Messages In This Thread
Mechanical OFF/ON indicator - by Croydonradio - 07-28-2021, 08:22 AM
RE: Mechanical OFF/ON indicator - by Brad Winder - 07-28-2021, 02:44 PM
RE: Mechanical OFF/ON indicator - by Croydonradio - 08-01-2021, 06:38 AM
RE: Mechanical OFF/ON indicator - by Croydonradio - 08-17-2021, 08:43 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 3883 online users. [Complete List]
» 3 Member(s) | 3880 Guest(s)
AvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration