Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Magnavox Provincial
#8

I think I found it. The last digit on the changer in question is a blip from the rubber stamp.

It looks like Collaro. The pickup arm is held on the rear end of it by two snap fasteners. The playing end of the arm is pointed, and I can't imagine anything that could replace the cartridge. You just pry the arm loose at te rear end. It will snap off.

I'd need to see a set of Collaro notes to be absolutely sure. The service notes I have are a Magnavox publication, and the way they talk, it's THEIR changer.


Messages In This Thread
Magnavox Provincial - by PFJC2 - 02-22-2011, 07:45 PM
Re: Magnavox Provincial - by Ron Ramirez - 02-22-2011, 09:59 PM
Re: Magnavox Provincial - by PFJC2 - 02-23-2011, 12:28 AM
Re: Magnavox Provincial - by Ron Ramirez - 02-23-2011, 10:14 AM
Re: Magnavox Provincial - by Doug Houston - 04-17-2011, 12:03 AM
Re: Magnavox Provincial - by PFJC2 - 04-17-2011, 09:15 PM
Re: Magnavox Provincial - by Ron Ramirez - 04-18-2011, 05:43 AM
Re: Magnavox Provincial - by Doug Houston - 04-18-2011, 05:32 PM
Re: Magnavox Provincial - by PFJC2 - 04-20-2011, 04:16 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 16B Parts
The 16B's in the tombstone cabinet sport a 10 1/2" spkr vs the older cathedral sets which uses an 8". The p/p ...Radioroslyn — 12:58 AM
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM

[-]
Who's Online
There are currently no members online.

>