1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 42-123
Radioroslyn
Phorum Expert
*****
Posts: 7,286
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#13

10-10-2021, 12:34 PM
I would use both 100mmf caps as that's what the transformer requires to resonate the coils at 455kc.
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 42-123 - by texan george - 10-01-2021, 02:15 PM
RE: Philco 42-123 - by admin - 10-01-2021, 03:12 PM
RE: Philco 42-123 - by morzh - 10-01-2021, 06:15 PM
RE: Philco 42-123 - by Radioroslyn - 10-01-2021, 07:45 PM
RE: Philco 42-123 - by morzh - 10-01-2021, 09:57 PM
RE: Philco 42-123 - by Radioroslyn - 10-02-2021, 06:19 AM
RE: Philco 42-123 - by MrFixr55 - 10-02-2021, 09:17 AM
RE: Philco 42-123 - by texan george - 10-02-2021, 03:55 PM
RE: Philco 42-123 - by texan george - 10-04-2021, 09:44 PM
RE: Philco 42-123 - by Radioroslyn - 10-04-2021, 11:30 PM
RE: Philco 42-123 - by texan george - 10-05-2021, 11:36 AM
RE: Philco 42-123 - by texan george - 10-10-2021, 09:43 AM
RE: Philco 42-123 - by Radioroslyn - 10-10-2021, 12:34 PM
RE: Philco 42-123 - by radiorich - 10-10-2021, 12:51 PM
RE: Philco 42-123 - by texan george - 10-10-2021, 02:28 PM
RE: Philco 42-123 - by texan george - 10-13-2021, 01:17 PM
RE: Philco 42-123 - by mikethedruid - 10-13-2021, 02:18 PM
RE: Philco 42-123 - by texan george - 10-13-2021, 03:35 PM
RE: Philco 42-123 - by RodB - 10-13-2021, 04:20 PM
RE: Philco 42-123 - by texan george - 10-15-2021, 01:37 PM
RE: Philco 42-123 - by Radioroslyn - 10-15-2021, 03:41 PM
RE: Philco 42-123 - by texan george - 10-16-2021, 04:22 PM
RE: Philco 42-123 - by morzh - 10-16-2021, 08:38 PM
RE: Philco 42-123 - by texan george - 10-24-2021, 05:10 PM
RE: Philco 42-123 - by MrFixr55 - 10-24-2021, 09:44 PM
RE: Philco 42-123 - by texan george - 10-26-2021, 01:50 PM



Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM

[-]
Who's Online
There are currently 5140 online users. [Complete List]
» 1 Member(s) | 5139 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration