Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Questions on Model 20 cabinet/speaker
#1

Okay, I sort of lucked into this chassis that only needed a couple of tubes to get going again.
The price paid wasn't too bad but it was about as much as the shipping so, I'm limited to what I can put into a speaker/cabinet and not be upside down in the radio.

I didn't acquire it to restore, I just wanted a parts backup for my Grandad's radio. I AM upside down in that radio, but I'm being "philco-sophical" about that.

I can stand pat with what I have and consider it "mission accomplished", but if I could find a speaker/cabinet (even if the cabinet was a little bit dinged up) I think it'd help the value of THAT radio considerably.

So, being an obvious neophyte, what's the path of least economic peril?  Is the speaker the unobtanium in this scenario?  The spread between buying a pretty decently restored radio complete and a cabinet/speaker is surprisingly narrow, at least from where I sit.  Any advice is greatly appreciated.  PM if it's easier.


Messages In This Thread
Questions on Model 20 cabinet/speaker - by RTM - 10-30-2021, 05:21 AM
RE: Seeking Model 20 cabinet/speaker - by RTM - 10-30-2021, 08:01 AM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Model 80 Antenna Issue?
I’ve replaced all the caps and resistors and the radio is working but minimal volume unless I put my hand near the re...Hamilton — 08:24 PM
Looking for any info: 1977 Ford-Philco Console Hi-Fi Turntable and Radio
Hi there! this is my first time posting. I recently picked up this Ford-Philco Console record player and radio at a yard...PittsburghToast — 07:28 PM
philco predicta
I found that where I have the 140v B+ there is 50v and the tuner receives 235v through the orange cablecgl18 — 04:14 PM
Philco 91 code 221
Chassis grounds thru rivets is another good place to look. Oh and the stator screws on the tuning cap where the leads at...Radioroslyn — 08:11 AM
Philco 91 code 221
Dirty tube pins and socket, cold solder joint, stray tiny strand of wire, clean the entire area around the oscillator tu...RodB — 08:43 PM
Philco 91 code 221
I have been restoring one of these sets and switched it on yesterday. It didn't exactly spring into life, but after a co...Philconut — 08:26 PM
Philco 50-925 antenna connections
That's super. Glad to hear you figured it out. Paul.Paul Philco322 — 11:11 AM
Philco 50-925 antenna connections
Hello Keith, great news !! Sincerely Richardradiorich — 02:14 AM
Philco 50-925 antenna connections
Finally, got the antenna fixed (repaired some broken wires) and have the radio playing. I've got four different schemat...keith49vj3 — 09:38 PM
1949 Motorola 5A9M
Bob, Nice radio.  I’ve not seen one before.  Keep us updated!Joe Rossi — 07:56 PM

[-]
Who's Online
There are currently 1336 online users. [Complete List]
» 2 Member(s) | 1334 Guest(s)
AvatarAvatar

>